Instruction Manual

14 15
Using Chase Select/LX
with the Internal 5-pt
Harness
If the child weighs more than 18 kg (40 lbs) or
their shoulders are above the highest harness level,
you MUST use this child restraint as a Booster.
WARNING
IMPORTANT
Evenflo strongly recommends using the top
anchorage (tether) strap when using this seat
with the internal harness. Using the tether strap
will improve the stability of the child restraint
and may reduce the risk of injury.
Tether Strap
Child Requirements
Weight: 10 – 18 kg (22 – 40 lbs)
Height: 71 – 127 cm (28 – 50 inches)
tall, or less, AND the tops of the child’s
ears are at, or below, the top of the
child restraint headrest.
Age: At least one year old
Harness straps
are at, or slightly
above, the child’s
shoulders.
1. Secure child restraint to the vehicle seat.
✔ Locking clip is installed, if necessary (p. 20).
✔ Child restraint is securely installed with lower
anchor connector assembly (shown at left)
through belt path (p. 16)
OR
Child restraint is securely installed with vehicle
seat belt through belt path (p. 19)
✔ Tether strap is attached and tightened (p. 18/21).
2. Place the child in the child restraint.
✔ The child’s back and bottom are flat against the
back and bottom surfaces of the child restraint.
✔ The top of the child’s ears MUST be at, or below,
the top of the child restraint headrest.
3. Make necessary adjustments.
✔ Harness straps are snug against the child’s
shoulders, with no slack (p. 23).
✔ Crotch strap is properly positioned (p. 27).
4. Fasten both buckle tongues. Refer to page 22.
5. Position and connect chest clip.
✔ Chest clip MUST be at armpit level (p. 23).
6. Check your work.
✔ To properly protect the child, the child restraint
MUST NOT move more than 25 mm (1 inch)
from side-to-side or from front-to-back at the
belt path.
To make installation easier, watch the installation
video of this child restraint at www.evenflo.com.
TIP!
TIP!
Using with the 5-pt Harness
Installation Checklist