User's Manual

1. Free Run: The LFO will never retrigger when it receives a note on
event.
2. Retrigger: The LFO will retrigger when it receives a note on event.
Retrigger is applied on a per-voice basis.
3. Play Sync: If your DAW’s transport isn’t in "Play", the LFO will retrigger
when it receives a note on event. Setting your DAW’s transport to
"Play" will cause the LFO to retrigger and ignore note events while
in "Play". Retrigger is applied across all voices.
PULSE WIDTH
The PULSE WIDTH knob will set the pulse width of the triangle and pulse
waves.
PHASE
The PHASE knob will set the LFO’s phase offset.
LFO Outputs
1. Sine outputs a sine wave
2. Triangle outputs a triangle wave. Control the triangle’s width using
the Pulse Width knob.
3. Pulse outputs a pulse wave, also known as a square wave. Control
pulse/square’s width using the Pulse Width knob.
4. Saw outputs a down-going sawtooth wave.
5. Ramp outputs an upward-going ramp wave.
3.4.4 Sample + Hold
The Sample and Hold (S+H) module provides a source of randomness to
the modulation section.
18