User Guide

H9 User Guide System Mode
28
Dump (Back-up) Presets & System Settings
The currently loaded effect, your stored Presets and your system settings can be dumped to a
MIDI device or to a computer using the MIDI’s SysEx facility. SysEx dump is a MIDI System
Exclusive Message that can be sent from the H9 and recorded by a MIDI sequencer or
computer. The H9’s Presets and System Settings can then be restored at a later time. This is a
useful way to backup saved settings or to reconfigure the unit as it was on your previous
project.
To Dump Presets &/or System Settings:
1) Press and hold the HOTKNOB button and Right Footswitch simultaneously for
a few seconds to enter System Mode.
2) Turn the Knob until [MIDI] is displayed.
3) Momentarily press the HOTKNOB button.
4) Turn the Knob until [DUMP] is displayed.
5) Momentarily press the HOTKNOB button.
6) Turn the Knob to select [ALL], [ACTIVE], [PRSETS] or [SYSTEM].
7) Press the HOTKNOB to start the SysEx dump.
8) Wait until dump is complete.
9) Press and hold the HOTKNOB button and Right Footswitch simultaneously for
a few seconds to exit System Mode.
Note: If [ACTIVE] is selected only the currently loaded Preset is dumped. If [PRSET] is selected,
all Presets are dumped. With ALL selected Presets and System settings are dumped. If SYSTEM
is selected, only System settings are dumped.
Restoring Presets and System Setting
Presets and System settings are restored via MIDI’s SysEx facility. The H9 must be set to the
desired SysEx ID number (from 1 to 16).
To set the MIDI SysEx ID number (factory default is 1):
1) Press and hold the HOTKNOB button and Right Footswitch simultaneously for
a few seconds to enter System Mode.
2) Turn the Knob until [MIDI] is displayed.
3) Momentarily press the HOTKNOB button.
4) Turn the Knob until [SYS ID] is displayed.
5) Momentarily press the HOTKNOB button.
6) Turn the Knob to choose SysEx ID from [ID 1] to [ID 16].
7) Press and hold the HOTKNOB button and Right Footswitch simultaneously for
a few seconds to exit System Mode