User Guide

H9 User Guide System Mode

The parameters controlled in this mode are system-wide and will apply to all Presets. For

example, you could assign an Aux Switch to Decay (KB1) with [MIN VAL] set to 1 sec and

[MAX VAL] set to 2 sec. Pressing the switch will toggle between these two decay values. If

another Effect or Preset is chosen, the Aux Switch will affect the parameter controlled by KB1

for the currently loaded effect.

Note: When a Preset is loaded, the switches assume the MIN VAL for the assigned

parameters. Pressing the switch for the first time after a Preset load, will change the

parameter to MAX VAL.

To Setup the External Control Source

Press the Right Footswitch to select one of three Aux Switches. There are two ways to select

the Aux Switch - Manual Select or Learn Mode.

For Manual Select, turn the Knob to choose the Aux Switch. The choices are:

[TIP] - Aux switch jack tip connection

[RNG] - Aux switch jack ring connection

[T+R] - Aux switch jack tip + ring connection

Note: If [EXPTIP] is set to [PEDAL] in [UTILS] only [RNG] is available.

To use the Learn Mode to select the external control source, press the Right Footswitch again.

“

LEARN”

is displayed prompting you to press an Aux Switch for automatic assignment. Press

the Right Footswitch again to exit LEARN mode and revert to manual source selection.

Press the Left and Right Footswitches to toggle between Source and Destination to make as

many assignments as you wish. The default settings for Aux Switch control are as follows:

[BYP.TIP]

[PR+.T+R]

[PR-.RNG]

Note that the other Control Destinations ([PSW], [TAP], [KB0]-[KB9], and [TUN]) are

unassigned as indicated by [---].

When done,

Press the PRESETS button

to go to top level System menu.

[MIDI] - MIDI Functions

After entering System mode, turn the Knob to select [MIDI], and then press the HOTKNOB

button to enter the MIDI functions settings mode.

Turn the Knob to scroll through the MIDI functions including MIDI Program maps, MIDI

channel, MIDI Data Dumps, etc.

[RCV CH] – Set the MIDI Receive Channel (OFF, OMNI, 1-16)

Press the HOTKNOB button to select. Turn the Knob to set the MIDI Receive Channel option.

You can select a MIDI Channel number [1] –[16], turn OFF MIDI receive or choose OMNI to

receive on all MIDI channels.

Press the PRESETS button

once to back-up one level to MIDI menu.

Press the PRESETS button

twice to go to top level System menu.