User Guide

H9 User Guide System Mode

[XMT CC] –Transmit MIDI Continuous Control

The H9’s Expression Pedal, knobs and Aux Switches can be used as MIDI controllers. Here’s

how it works: Press the HOTKNOB button to select [XMT CC]. You will see two fields (split

display) with the left side of the display showing the Control Source and the right side the

Destination. The two fields are delimited by a decimal point [PDL.C15].The Left Footswitch

LED is flashing (if it’s not, press the Left Footswitch to select this field) showing this to be the

selected field for editing.

To Select the Control Source

Turn the Knob to select the Control Source. The choices are:

[PDL] Expression Pedal

[KB0]…[KB9] - Parameter Control Knobs

[TIP] Aux Switch Tip

[RNG] Aux Switch Ring

[T+R] Aux Switch Tip+Ring

Note: Assigning parameter knobs (KB0-KB9) allow you send MIDI messages ‘through’ the H9

when using H9 Control.

To Assign the Control Source to a Destination

Press the Right Footswitch to select the MIDI Continuous Control that will be assigned to the

H9 Control Source. The choices are:

[OFF] – Control Source unassigned

[C0] – [C99] - MIDI Continuous Controller from 0 to 99

Press the Left and Right Footswitches to toggle between Source and Destination to make as

many assignments as you wish. The default patch is as follows: [PDL.C15] and [KB0.C22]

through [KB9.C31]

Press the PRESETS button

once to back-up one level to MIDI menu.

Press the PRESETS button

twice to go to top level System menu.