User Guide

H9 User Guide System Mode
40
The Left field displays the Preset number (P1 to P99). The right field displays either
OFF
or the
Prg No. (0-127). Default map: Prg No. 0-99 map to Presets P1 to P99.
Press the Left Footswitch
to select Preset field (indicated by the flashing Left Footswitch LED),
turn the Encoder
to select the Preset.
Press the Right Footswitch
to select Prg No. field (indicated by the flashing Right Footswitch
LED),
turn the Encoder
to select the corresponding number.
Note: MIDI Program Change Transmit must be enabled in order for the H9 to transmit
Program Change messages. MIDI Program Change Transmit is turned ON or OFF in the MIDI
menu. Default is OFF.
Note: When an H9 Preset is recalled with a MIDI program change message, MIDI Program
Change messages are not generated unless XMT.PC (see below) is set to ON.
Press the PRESETS button
once to back-up one level to MIDI menu.
Press the PRESETS button
twice to go to top level System menu.
[XMT.PC] – MIDI Program Change Re-Transmit Enable (ON, OFF)
Press the HOTKNOB button to select. Turn the Knob to set MIDI Program Change re-transmit
ON or OFF. This setting determines if a MIDI Program Change message is sent when a
program is loaded as the result of receiving a MIDI Program Change.
Press the PRESETS button
once to back-up one level to MIDI menu.
Press the PRESETS button
twice to go to top level System menu.
[CTL.XMT] – MIDI Continuous Controller Transmit Enable (ON, OFF)
Press the HOTKNOB button to select. Turn the Knob to set MIDI Continuous Controller
transmit ON or OFF. This setting determines if Parameter transmit MIDI control messages are
enabled.
Press the PRESETS button
once to back-up one level to MIDI menu.
Press the PRESETS button
twice to go to top level System menu.
[PGM.XMT] – MIDI Program Change Transmit Enable (ON, OFF)
Press the HOTKNOB button to select. Turn the Knob to set MIDI Program Change transmit
ON or OFF. If ON, a MIDI Program change message is transmitted whenever a Footswitch is
pressed for Preset load.
Press the PRESETS button
once to back-up one level to MIDI menu.
Press the PRESETS button
twice to go to top level System menu.
[SYS ID] – MIDI SysEx ID (ID 1-ID 16)
Press the HOTKNOB button to select. Turn the Knob to choose the MIDI SysEx ID for Backup
and Restore of Presets and System settings.