User Guide

H9 User Guide System Mode
43
[AUDIO] – Choose audio function when Tuner is active (BYPASS, MUTE)
Press the HOTKNOB button to select. Turn the Encoder to choose BYPASS or MUTE. When
BYPASS is selected, whenever the H9’s tuner is enabled, the audio input is connected to
audio out. When MUTE is selected, audio is muted when tuning.
Press the PRESETS button
once to back-up one level to TUNER menu.
Press the PRESETS button
twice to go to top level System menu.
[CALBRT] – Calibrate Tuner’s Reference Frequency (440 Hz)
Press the HOTKNOB button to select. Turn the Encoder to adjust the Tuner’s reference
frequency from 420 Hz to 460 Hz. 440 Hz standard is the default. This value will also
establish the ‘A’ tuning for the pitch effects.
Press the PRESETS button
once to back-up one level to TUNER menu.
Press the PRESETS button
twice to go to top level System menu.
[UTILS] - Utility Functions
After entering System mode, turn the Knob to select [UTILS], then press the HOTKNOB to
enter the Utility functions settings mode. Turn the Knob to scroll through the Utility functions.
[ROUTE] – Select the Routing Mode (NORMAL, PRE.PST, WET.DRY)
Press the HOTKNOB button to select. Turn the knob to select the Routing Mode. See the
Routing section of this manual for more information on Routing Modes.
Press the PRESETS button
once to back-up one level to UTILITY menu.
Press the PRESETS button
twice to go to top level System menu.
[PRESET] – Select the range of Active Preset (L01 - H99)
Press the HOTKNOB button to select. Press the Left Footswitch and turn Knob to set the
lower limit and the Right Footswitch and turn Knob to set the higher limit. The default is [01--
99]. Only Active Presets can be loaded by Footswitch and PRESETS button and Knob on the
stompbox. All Presets may still be loaded using MIDI program change.
Press the PRESETS button
once to back-up one level to UTILITY menu.
Press the PRESETS button
twice to go to top level System menu.
[SOURCE] – Select Source Instrument (GUITAR, BASS, SYN.LD, SYN.BAS)
Press the Encoder to select. Turn Encoder to select the type of instrument (SYN.LD=Synth
Lead, SYN.BAS=Synth Bass). Each instrument setting optimizes the pitch algorithms and
adjusts the ranges of filter knobs to best complement the selected source instrument.
Press the PRESETS button
once to back-up one level to UTILITY menu.
Press the PRESETS button
twice to go to top level System menu.
[INGAIN] – Set the input gain (0dB to +18dB)
Press the HOTKNOB button to select. Turn the Knob to select the gain value.