User Manual

Mixing Link User Guide I/O Connectors

The“AUX”jackenablesyoutouseyourmobiledeviceas an effects processor while

keeping the rest of your effects chain signal path intact. It also allows Mixing Link to serve

asanaudiointerfaceforrecordingdirectlyintoyourmobiledevice.The“AUX”connector

also allows for stereo playback of audio from an external source to be mixed with your mic

or instrument.

OUTPUTS

(18) TO AMP Phonejack

Unbalanced mono output for connecting the Mixing Link to a guitar amp, another effects

pedal,ortoanyinputthatacceptsanunbalanced¼”plug.

When theFXLoopisactive,the“TOAMP”signaloriginatesattheoutputoftheMIXknob.

DeactivatetheFXLoopand“TOAMP”outputstheMICpre-amp directly.

ThePHONES&AMPLEVELknobalwayscontrolstheoutputlevelat“TOAMP”whether

or not the FX Loop is activated.

The AUX input signal is always sent to the“TOAMP”jackasamonoversionofthestereo

AUX signal.

(19) PHONES Phonejack

Stereo,poweredversionofthe“TOAMP”outputwiththeabilitytodriveheadphones.

The signal originates at the output of the MIX knob when the FX Loop is active; otherwise

it outputs the MIC pre-amp.

ThePHONES&AMPLEVELknobsetsthevolumelevelatthe“PHONES”outputatall

times.

ThestereosignalfromtheAUXjackisoutputinstereotothe“PHONES”jack at all times.

(20) DI/LINE OUT XLR Connector

ThesignalpresentatthisXLRoutputisabalancedversionofthe“TOAMP”output

except it bypasses the PHONES & AMP LEVEL knob.

Bypassing the LEVEL knob allows you to set your stage volume when connecting to the

“TOAMP”outputwithoutaffectingtheDIfeedtothePAsystem.

The output level is switchable between a low level DI output and a high level LINE output

using the small DIP switch located on the underside of Mixing Link. Set the DIP switch to

DI when connecting to an input that expects a MIC level signal; use the LINE setting when

connecting to a line level input. The factory default setting is LINE.

(21) PWR Jack

Insert the output plug from an AC Adapter into the PWR Jack. The plug must be center

negative 2.1mm and provide 200mA at 9VDC. The maximum allowable voltage that can

be connected to the PWR jack is 12VDC.