User Manual

Mixing Link User Guide Under The Cover
10
UNDER THE COVER
RemovingMixingLink’sbottomcoverrevealstwouseraccessiblefeatures:9VBatteryclip
and Tails On/Off switch. When making changes to these two features, please do not touch
any other parts of the circuit board or you risk damaging your Mixing Link.
9V BATTERY
Mixing Link is capable of running from a standard 9V battery, we recommend alkaline. Set
the 48V switch to OFF to disconnect the battery from the circuit.
TAILS ON/OFF
Tailsisthecommontermforanechoordelay’srepeatsorthesoundofyournote
decaying on a reverb effect.
Tails OFF: When the FX Loop is deactivated any reverb tail or delay repeats that the FX
LoopisproducingwillbemutedimmediatelyupondeactivatingtheFXLoop.Both“TOFX”
outputand“FROMFX”inputaremuted.
TailsON:Adelay’srepeatsorareverb’stailwillcontinuetobeaudibleupondisengaging
the FX Loop. Although the “TOFX”outputisimmediatelymutedsononewaudiogoesout
intotheFXLoopwhenTailsisON,the“FROMFX”inputremainsliveanditssignalis
always present at the MIX knob.
If Tails is set to ON and the FX Loop is disengaged, turning the MIX knob will change the
volumeofthe“FROMFX”signalbutitwillnotaffecttheMICpre-amp’soutputlevel,which
remains at unity.
To change the Tails setting, remove the bottom cover of Mixing Link and flip the DIP
switch labeled SW6, located just above the footswitch. When set to the right direction
(towards“TOAMP”)TailsissettoON.Intheleftdirection(towards“INSTIN”)Tailsisset
to OFF.
Tails Off is the factory default setting.