User Manual

Mixing Link User Guide Controls and Indicators

(5) MIX MODE Toggle Switch

This three-position switch determines how the DRY and FX Return signals interact when

turning the MIX knob.

The DRY signal is the signal at the output of the MIC pre-amp stage. The source for the

DRYsignalcomesfromeithertheMIC/LINEINXLRconnectorortheINSTIN¼”phone

jack.

TheFXReturncomesfromthe“FROMFX”(RETURN)phonejack.

The three MIX switch modes are as follows:

DRY+FX: The level of the DRY signal is fixed; the level of the FX

Return signal increases as you turn the MIX knob

clockwise. DRY+FX keeps your microphone or instrument

level fixed while you dial in just the right amount of FX

Return.

MIX: The MIX knob acts like a wet/dry control. With the MIX knob

at full counter-clockwise, you will hear only the DRY signal.

At full clockwise, you will hear only the FX Return. Turn the

MIX knob to balance the two signals to taste.

FX ONLY: The DRY signal is muted, you will not hear your

microphone, line or instrument input while the FX Loop is

engaged. The MIX knob acts like a volume control for the

FX Return signal. As you turn MIX knob clockwise, the FX

Return level increases.

(6) PHONES & AMP LEVEL Knob

SetstheoutputlevelfortheMixingLink’stwomainoutputjacks:“TOAMP”and

“PHONES”.ThisknobcontrolstheoutputlevelwhetherornottheFXLoopisengagedor

bypassed.

(7) FX LOOP Footswitch and Status LED

TheFXLOOPfootswitchactivates/deactivatestheFXLoopconnectedbetweenthe“TO

FX”and“FROMFX”jacks,allowingyoutoturnonoroffyoureffectschainwiththetapof

a switch.

When the status LED located above the footswitch is lit, the FX Loop is activated, sending

your DRY signal out to the FX Send jack. When the status LED is off, the FX Loop is

deactivated and muted.

The FX LOOP footswitch can work as either a momentary or latching switch, the

HOLD/LATCH toggle switch above the footswitch changes its action.

(8) HOLD/LATCH Switch

This toggle switch, located just above the footswitch, changes the action of the FX Loop

footswitch - either latching or momentary.

When set to the LATCH position, the FX Loop status changes state upon pressing the

footswitch and remains in this new state until you press the footswitch again; releasing the

footswitch does not cause the FX Loop status to change.