Operator`s manual

Model VR240 Audio Logging Recorder

January 2000

2-3

2-3 INITIAL TURN-ON.

NOTE

The VR240 is factory-configured for the line voltage of the country

of installation. Fuse size is 2A, 250V. Refer to paragraph 2-7 for

ensuring correct power.

2-3.1 Power.

The VR240 does not have an ON/OFF switch. To apply power, first plug the power cord into

the rear panel power connector. Next, plug the other end of the cord into a power outlet. The

logger turns on and operates continuously when plugged in.

2-3.2 Self Test.

The unit performs a self-test after power is applied. Then the following screen will appear on

the VFD display:

2-3.3 Front Panel Controls.

There are three sets of controls on the VR240 front panel. The transport control keys are

immediately underneath the drive(s). The keypad is on the right of the panel above the

headphone jack. The soft keys are underneath the VFD display. Refer to Section III of this

chapter for a more detailed description of the front panel controls and indicators.

Figure 2-2. VR240 Front Panel

Upper: Not Ready

Controls SysInfo Drive Config

Rec

Play

Rew

FFwd

Stop

Eject

Channel Status

Full

Almost Full

Fault

Phones

Relay

Eventide

VR240

Digital Audio

Logging Recorder

R A M

DVD

R A M

DVD