Operator`s manual

Model VR240 Audio Logging Recorder
3-20
January 2000
b. Select the timers and cycle parameters.
SetTimers
allows you to set the time and date of three operations:
StartRec
Sets the time that the recorder begins operation.
SwapRec
Sets the time at which the drives on a two-drive recorder switch
over. (The drives will switch automatically if this timer is not set.)
This parameter is not available on
single drive
recorders.
StopRec
Sets the time at which the unit will stop recording.
All three timer settings work in a manner identical to that of the
Clock
, discussed earlier in
paragraph 2-3.5.
SetCycle
gives you a display showing how often a recording will occur.
Change
cycles through the following choices:
Once
a recording will be made and
AutoRec
will be exited
Weekly
the recording will be made once a week at the date and time
indicated
Daily
the recording will be made every day at the time indicated
Weekdays
the recording will be made every day, at the time indicated, except on
Saturday and Sunday
Hourly
the recording will be made every hour at the start and end times
indicated
NOTE
In order to perform the multiple recording function, the
Timers
are
automatically reset by the increment specified after their function
is activated. For instance, once you have started a
Daily
recording, the
Start Timer
is automatically incremented by a day.
Done
exits the
SetCycle
choices and leaves the selection displayed at that time
active.
ClearTimers
clears any settings you may have entered in the timers and resets them to
the current time. The
ClearTimers
soft key is accessed by pressing the
>
(next) soft key from the Automatic Record Configuration menu.
3-21.1 Notes on Auto Record Timer Settings.