Operator`s manual

Model VR240 Audio Logging Recorder
3-24
January 2000
Select the following System Info options as required:
Internal
Sampling:
Reveals the transcoding rate.
Descript:
(Descriptors) Allows you to cycle through the channel numbers and view the
descriptors. Use the Channel # - (minus) and + (plus) soft keys to scroll
through the descriptors. Use the < (previous) and > (next) soft keys to view
descriptors that are longer than the display line.
UnitNum
: (Unit Number) displays serial number and software version.
DriveInfo
ActvHours:
Displays the number of hours the drive has been active since it was installed.
This will displayed the active status of the selected archive drive. To view the
status of the other archive drive, go back a few menu pages until you find the
Drive soft key. Press this soft key until the required drive status appears in
the top line of the display. Then return to the SysInfo menu.
Cleaned:
Keeps a record of the last time you reset your cleaning timers. You must
reset these timers every time you clean a drive. Cleaning timers that have not
been reset will cause the VR240 to light the front panel “fault” LED. Refer to
paragraph 5-3, DATA DRIVE CLEANING.
SysLogs
ErrorLog
displays unusual events that have occurred since power was most recently
applied. Use the Older and Newer soft keys to scroll through the log. This
feature is presently used for factory diagnostic information. If you experience
difficulty with the unit, note the Error Log information before turning the unit
off.
HistoryLog
displays the events such as when media have started, stopped, loaded, and
been ejected. This log can be viewed to determine a recent history of the
unit’s operation. Use the Older and Newer soft keys to scroll through the log.
Quit
Press the Quit key on the keyboard to exit this screen or simply wait for a
time-out to occur.
Printout
Press the Printout soft key for a printed report of the Error and History Logs.