Operator`s manual

Model VR240 Audio Logging Recorder
January 2000
3-31
3-28.2 Setting the VOX Level.
a. After pressing the
Config
and the
>
(next) soft key, press the
Board
soft key. Then
press the
VOX
soft key.
b. Press the
Level
soft key.
Channel
scrolls through the installed channels (1 through 8, 16, 32, or 48) and
shows you their current settings. 320 millivolts is the factory default.
Decrease and Increase
will change the VOX level settings.
Done
save the setting that appears on the display and exits you from this
screen.
NOTE
Voltage levels are only an approximation and will vary from line to
line. Some experimentation will be necessary for optimum results.
3-29. AUDIO GAIN.
AudioGain
sets the level of the signal being recorded on each input. If there is audio present
on the channel you are setting, you will hear it during this configuration process.
VOX HOLD: Channel 01 : 01
< Channel Decrease Increase Enter >
VOX LEVEL: Channel 01 : 320 millivolts
Channel Decrease Increase Done