User guide

PitchFactor User Guide Tuner
15
Global Mix
The Mix setting is always saved with each Preset. Often however, it can be useful to have the
Mix setting uniform for all of the Presets that you’re using. To do this, use the System
GLOBAL MIX command. When GLOBAL MIX is ON, the Mix setting saved with the Preset is
ignored and the current Mix setting is used for all Presets.
Turning GLOBAL MIX ON or OFF. The factory default is OFF.
1) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to enter System Mode. Release the Encoder.
2) Turn the Encoder until [GLOBAL] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [MIX] is displayed.
5) Momentarily press the Encoder.
6) Turn the Encoder to select [ON] or [OFF].
7) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to exit System Mode.
Peak LED
The Peak LED lights to indicate that the input signal level is near clipping. Occasional flashing
is OK. If Peak LED is lit solidly, reduce the input level either by reducing the signal level fed to
PitchFactor or by setting the rear panel input switch to the Line position. PitchFactor has a
soft clipping circuit that will reduce nasty noises when overloaded.
Tuner
In Play Mode, press and hold the Middle and Right Footswitches simultaneously to enable the
tuner. Press any of the Footswitches to exit the tuner.
When the tuner is enabled, audio is either Bypassed or Muted as determined by the setting in
System Mode. The default setting is Muted.
PitchFactor supports two types of tuner display: a graphic display and a numerical (cents)
display. Press the encoder to toggle between the two.
The tuner’s default reference frequency is set to 440 Hz. See System Mode for instructions on
changing the reference frequency.