User guide

PitchFactor User Guide System Mode

[XMT MAP] – Create a MIDI Program Change Transmit Map

In Bank Mode, when a Footswitch is used to recall a Preset, a MIDI Program Change message

can be transmitted from the MIDI Out jack or USB to control an external device - e.g. another

Factor series Stompbox, an Eventide Eclipse, an Eventide H000FW, etc.

To Create a MIDI Program Change transmit map Press the Encoder to access the MIDI

transmit map for editing.

The left field displays the Bank Preset number (from 1:1 to 50:2). The right field displays

either OFF or the Prg No. (0-127). Default map: Prg No. 0-99 map to the 100 Presets starting

with Bank 1:1.

Press the Left Footswitch to select Preset/Effect field (indicated by a flashing left hand arrow

pointing), turn the Encoder to select the Preset.

Press the Right Footswitch to select Prg No. field (indicated by a flashing right hand arrow

pointing to MIDI Program Change #), turn the Encoder to select the corresponding number.

Note: MIDI Program Change Transmit must be enabled in order for PitchFactor to transmit

Program Change messages. MIDI Program Change Transmit is turned ON or OFF in the MIDI

menu. Default is OFF.

Note: When a Factor Preset is recalled with a MIDI program change message, MIDI Program

Change messages are not generated.

Press the Middle Footswitch once to back-up one level to MIDI menu.

Press the Middle Footswitch twice to go to top level System menu.

[CTL XMT] – MIDI Continuous Controller Transmit Enable (ON, OFF)

Press the Encoder to select. Turn Encoder to set MIDI Continuous Controller transmit ON or

OFF. This setting determines if Parameter Knobs transmit MIDI control messages.

Press the Middle Footswitch once to back-up one level to MIDI menu.

Press the Middle Footswitch twice to go to top level System menu.

[PGM XMT] – MIDI Program Change Transmit Enable (ON, OFF)

Press the Encoder to select. Turn Encoder to set MIDI Program Change transmit ON or OFF.

If ON, a MIDI Program change message is transmitted whenever a Footswitch is pressed for

Preset load.

Press the Middle Footswitch once to back-up one level to MIDI menu.

Press the Middle Footswitch twice to go to top level System menu.

[SYS ID] – MIDI SysEx ID (1-16)

Press the Encoder to select. Turn Encoder to choose the MIDI SysEx ID for Backup and Restore

of Presets and System settings.

Press the Middle Footswitch once to back-up one level to MIDI menu.

Press the Middle Footswitch twice to go to top level System menu.