User guide

PitchFactor User Guide System Mode

[BANKS] – Select the range of Active Preset Banks (1 - 50)

Press the Encoder to select. Press the Left Footswitch to select the lower limit and the Right

Footswitch to select the higher limit. Turn Encoder to set the lowest and the highest active

banks. Only Presets saved in active Banks are available for loading using the Footswitches. All

Presets may still be loaded using MIDI program change.

Press the Middle Footswitch once to back-up one level to UTILITY menu.

Press the Middle Footswitch twice to go to top level System menu.

[SOURCE] – Select Source Instrument (GUITAR, BASS, SYNLEAD, SYNBASS)

Press the Encoder to select. Turn Encoder to select the type of instrument. Each instrument

setting optimizes the pitch algorithms and adjusts the ranges of filter knobs to best

complement the selected source instrument.

Press the Middle Footswitch once to back-up one level to UTILITY menu.

Press the Middle Footswitch twice to go to top level System menu.

[SER#] – Serial Number

Press the Encoder to display your PitchFactor’s unique serial number. You’ll need to know this

number to request support and to download software updates.

Press the Middle Footswitch once to back-up one level to UTILITY menu.

Press the Middle Footswitch twice to go to top level System menu.

[SW VER] - Software Version

Press the Encoder to display your PitchFactor’s software version.

Press the Middle Footswitch once to back-up one level to UTILITY menu.

Press the Middle Footswitch twice to go to top level System menu.

Restoring Factory Settings/Software Updates

Restoring Factory System Settings

To restore System settings, power up PitchFactor while simultaneously pressing the Right

Footswitch and the Encoder until [CLEAR SETUP] is displayed.

Restoring Factory Effects Presets and System Settings

CAUTION: This function will overwrite any Presets that you have saved.

To restore Factory Presets and all System settings, power up PitchFactor while simultaneously

pressing the Middle Footswitch and the Encoder until [INITIALIZING] is displayed.

Software Updates

PitchFactor’s software can be upgraded over USB. To enable the software update, power up

while pressing the Middle Footswitch until [UPDATE] is displayed. Information on software

updating can be found at www.eventide.com.