Installation Guide

WAX RING
INSTRUCTION GUIDE
2
3
4
5
6
1
After the Joni-bolts are placed in the desired location,
dry t the toilet to make sure the oor is level. (If it is
unlevel shim appropriately.)
Remove the toilet and leave the shims in place, excess
material can be cut off later. Place the wax seal onto
the ange.
Set the toilet down with a small twist but no rocking.
Secure the Johni-bolts.
Cut the bolts to t under the toilet bolt caps.
Once you have conrmed that your wax seal as created a water / air tight seal, caulk around the
base of the toilet to eliminate bacteria growth under the bowl.
©2020 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com