Installation Guide
Installation Guide
Regular Duty System Tips
HOMEDEPOT.com
Please contact 1-800-305-1726 for further assistance.
Install Hang Tracks
2
Choose Your Hardware
Regular Duty System Components
1
A. Hang Track
B. Vertical Rail
C. Shelf Bracket
D. Closet Rod
E. Closet Rod Support Bracket
F. Closet Rod Endcap
G. Shelf Endcap
H. Regular Duty Shelving
□ Determine your desired hang track conguration per your planned layout.
□ Measure 84 in. from the oor and level the hang track. Use a pencil to mark each screw hole, marking at least every 16 in.
apart (or closer) along hang track on the wall.
Secure to the wall with #12x2 in.
panhead screws at stud locations.
Drill 1/4 in. holes, insert 1/4 in. wall
anchors and secure to the wall with
#12x2 in. panhead screws.
STUDS
CONCRETE
DRYWALL
Drill a 1/2 in. hole in the drywall. If
you hit a stud during drilling, use
above stud hardware/instructions
for each stud location.
Insert bolt through hang track (or
vertical rail/vertical rail joiner) then
screw on 3/16 in. toggle.
Install 3/16 in. toggles in each hole of
the component you are attaching
before attaching to the wall.
Compress and pass the 3/16 in.
toggles through the hole you drilled.
Allow the 3/16 in. toggle to spring
apart behind the drywall.
Screw the 3 in. bolt until tight to
secure. Pull back on screw head
for tension if 3/16 in. toggle is
spinning behind wall. Install 3/16
in. toggles in each hole of
components before attaching to
wall.
A
B
E
F
G
D
H
C