Instructions / Assembly

Screwdriver Hack Saw Tape Measure
Channel Locks PVC Glue
PVC
YOU MAY ALSO NEED
Application
Thread Tape
Well seals1 in. discharge tee1 in. foot valve
25 ft. maximum
Bottom of well
5 ft. minimum
10 ft. minimum
1. Tie a small but heavy weight such as a fishing weight to the end of a piece of cotton string.
2. Lower the weight into the well until it reaches the bottom of the well.
3. Make a mark on the string at ground level.
4. Pull the weight out of the well and measure from the bottom of the weight to the ground
level mark.
5. This is the depth of your well. Subtract five feet from the depth of your well. This number
should not exceed 25 feet.
6. Measure the ground level mark to the mark where the string is wet. This number is your
well’s water level.
7. It should also be at least 10 feet below the well’s water level while the pump is running in
order to prevent the pump from sucking air due to water level drawdown.
PUMP IS PRESET TO 230 VOLTS. CHECK YOUR POWER SOURCE
(EITHER 115 VOLTS OR 230 VOLTS), AND MAKE SURE PUMP IS
SET TO CORRECT SETTING.
1. POWER off
2. Slide to the proper voltage
3. POWER on
10 ft Min.
5-10 ft Min.
2
3
4
5
6
1
1. Foot Valve
2. Pipe
3. Well Seal
4. Priming Tee and Plug
5. Check Valve
6. Priming Tee and Plug
To Household
Water System
25ft Max.
Determine the depth of your well