Installation Guide

13 For Professional Technical Support call 1-844-241-5521
Deep Well Installation (continued)
6
Slide a (H) 4 in. Well Seal over the (E)
PVC or Flexible Pipe
7
Attaching a (R) 1 in. PVC elbow and
(B) 1-1/4 in. priming tee to the PVC or
flexible pipe
 Remove the pipe clamp and slide the (H) 4 in. well seal (sold
separately) over the PVC or Flexible pipe and onto the well casing
(not shown).
 The PVC or Flexible Pipe should extend approximately 12 in. from
the well seal, depending on the height of the pump placement.
 Tighten the well seal until the rubber gaskets are tight against
the well casing and the PVC pipe.
 Attach a (R) 1 in PVC elbow and a (B) 1-1/4 in. priming tee
(both facing the pump) to the pipes extending from the well.
 Attach (Q) 1 in. PVC or flexible pipe to 1 in. elbow.
 Attach (P) 1-1/4 in. Male adaptor to the 1-1/4 in. PVC pipe from
well.
 Attach (E) 1-/4 in PVC or flexible pipe to 1-1/4 in priming tee.
8
Connecting rigid pipe to the pump body
9
Connecting the pipes from the well to
the pump
 Position the pump as close to the well as possible.
 Attach two sections of PVC or flexible pipe to the pump body (Q)
1 in. drive, and (E) 1-1/4 in. suction.
NOTE: If using PVC pipe to connect, a 1 in. x 3 in. nipple is
required.
 Measure the distance from the PVC pipe extended from the
check valve off the pump to the PVC pipe extending from the
priming tee from the well. This will be the length of PVC or
flexible pipe needed to connect the pump to the well for both 1
in. and 1-1/4 in. pipe.
 Using (I) Flexible PVC couplings or (F) PVC couplings to connect
both ends of the 1-1/4 in. PVC pipe to the pump and well end.
Use the (S) 1 in. PVC coupling to connect both ends of the 1 in.
PVC pipe to th pump and well end.
 Tighten the flexible pipe with clamps on each end.
 Ensure that the PVC or Flexible pipe slopes slightly downward
toward the well to prevent air trapping in the pipe.
(H) 4 in. Well Seal
~12 in.
(Q) 1 in. PVC or
flexible pipe
(E) 1-1/4 in. PVC pipe
(B) 1-1/4 in. priming tee
(R) 1 in. PVC Elbow
(P) 1-1/4 in.
Male Adapter
(P) 1-1/4 in.
Male Adapter
(E) 1-1/4 in.
PVC pipe
(C) 1 in. female adapter
(Q) 1 in. PVC or
flexible pipe
(I) Flexible Couplings or (F) PVC
Couplings for 1-1/4 in. pipe
(E) 1-1/4 in. PVC or
Flexible Pipe to connect
pump piping to well piping
(V) 1 in. Flexible
PVC Coupling
(Q) 1 in. PVC or
flexible pipe