Installation Guide

16 For Professional Technical Support call 1-844-241-5521

Deep Well Installation (continued)

Connecting the pump with the

water system

Voltage setting

CAUTION: Never install a shut-off valve between the

pump and the tank, as this can cause excessive friction

loss and can damage the pressure switch and/or pump. If

necessary, only install a fully open gate valve (sold

separately).

 Using PVC purple primer and PVC cement, attach a section of 1

in. PVC pipe (sold separately) as needed to connect the 3/4 in.

MNPT x 1 in. slip PVC adapter in the pressure regulator.

 Attach another section of 1 in. PVC pipe (sold separately) as

needed to connect the other 1 in. female PVC adapter on the tank

tee to the water system from the house.

WARNING: All electrical work should be performed by

a licensed electrician.

 This pump is pre-wired at 230 volts.

 If the power source is 115 volts, remove the electrical housing

cover.

 Flip the switch to 115 volts.

 Replace the cover.

Setting pressure regulator

 Turn the regulator adjustment screw down tight.

 Turn on pump.

 If the pump is properly primed, a high pressure will immediately

show on the pressure gauge.

 With the pump operating at high pressure, slowly unscrew the

adjusting screw until maximum water flow is obtained without

pressure dropping to zero.

 If pressure falls completely, retighten the screw and readjust it.

 If no pressure shows, stop the pump, remove the pressure

regulator from pump, add more water, and try again.

 After the adjusted bolt is set up, lock the screw nut on the bolt.

 The pump is ready for use.

NOTE: The pressure regulator screw is very tight. A big

screw driver needed.

Proceed to the Pressure Switch Assembly Instructions section on page 10 of this manual.