Installation Guide

2 For Professional Technical Support call 1-844-241-5521
Table of Contents
Table of Contents .......................................................... 2
Performance .................................................................. 2
Safety Information ......................................................... 2
Warranty ......................................................................... 3
Pre-Installation .............................................................. 4
Shallow Well Installation .............................................. 5
Pressure Switch Assembly Instructions ................... 10
Deep Well Pump Replacement .................................. 11
Troubleshooting .......................................................... 17
Performance
SKU HP
GPH of Water @ Total Discharge Pressure of 40 psi
Max. Pressure
0 ft. 10 ft. 20 ft. 30 ft. 40 ft. 50 ft. 60 ft. 70 ft.
1001480251 3/4 612 486 372 360 318 270 210 180 67 psi
1001480255 1 822 696 540 444 420 360 306 276 67 psi
Safety Information
DANGER: Do not pump flammable or explosive liquids
such as oil, gasoline, kerosene, ethanol, etc. Do not use in
the presence of flammable or explosive vapors. Using this
pump with or near flammable liquids can cause an
explosion or fire, resulting in property damage, serious
personal injury, and/or death.
DANGER: ALWAYS disconnect the power to the pump
before servicing.
DANGER: Do not touch the motor housing during
operation. The motor is designed to operate at high
temperatures. Do not disassemble the motor housing.
DANGER: Do not handle the pump or pump motor with
wet hands or when standing on a wet or damp surface, or
in water.
WARNING: Wear safety goggles at all times when
working with pumps.
WARNING: This is a dual voltage 115/230 V pump.
VOLTAGE SELECTOR INSIDE PRESET TO 230V.
For 115V selection, please open the terminal cover and set
the switch to the proper voltage. All wiring should be
performed by a qualified electrician.
WARNING: Protect the electrical cord from sharp
objects, hot surfaces, oil, and chemicals. Avoid kinking the
cord. Do not use damaged or worn cords.
WARNING: Failure to comply with the instruction and
designed operation of this unit may void the warranty.
ATTEMPTING TO USE A DAMAGED PUMP can result in
property damage, serious personal injury, and/or death.
WARNING: The pump should be connected to a
230V/115V GFCI outlet protected with a
10 amp (230V)/20 amp(115V) fuse or circuit breaker.
CAUTION: Know the pump and its applications,
limitations, and potential hazards.
CAUTION: Secure the pump to a solid base.
CAUTION: Periodically inspect the pump and system
components. Disconnect the pump from the power supply
before inspecting.
CAUTION: Follow all electrical and safety codes,
particularly the Canadian Electrical Code, and local codes
and ordinances.
IMPORTANT: The motor of this pump has a thermal
protector that will trip if the motor becomes too hot. The
protector will reset itself once the motor cools down and
an acceptable temperature has been reached. The pump
may start unexpectedly if it is plugged in.
IMPORTANT: Ensure the electrical power source is
adequate for the requirements of the pump.
IMPORTANT: This pump is made of high-strength,
corrosion-resistant materials. It will provide trouble-free
service for a long time when properly installed,
maintained, and used. However, inadequate electrical
power to the pump, dirt, or debris may cause the pump to
fail. Please carefully read the manual and follow the
instructions regarding common pump problems and
remedies.