Installation Guide

HOMEDEPOT.com
Please contact 1-844-251-7446 for further assistance.
F
Pre-Installation
1. The maximum water temperature in contact with the filter should not exceed 100°F (38°C) at 40 PSI.
2. The maximum water pressure within the filter should not exceed 150 PSI at 73°F (23°C). Colder temperatures reduce the
maximum operating pressure.
3. The Sediment Filter warranty does not cover any defects that may arise from use with non-potable water, chemicals or other
fluids.
4. Lubricants used on O-rings can contain chemicals that are not compatible with filter components. Silicone grease (DOW 111)
should be the only lubricant used on O-rings.
5. Adhere to all local and state codes, laws, and regulations when installing the filter.
Installation
1. Remove the filter bowl (E) and the filter cap O-ring (D) from the PVC Filter Cap (A).
2. The filter cap can be used with either 1 in. or 1-1/4 in. PVC pipe. If using with 1 in. PVC pipes, prime and glue the inside of
the filter cap (A) inlet and outlet as well as the outside of the PVC pipes. Insert the pipe directly into the filter cap and allow
the glue to set. If using with 1-1/4 in. PVC pipes, prime and glue the outside of the filter cap (A) inlet and outlet as well as the
inside of 1-1/4 in. PVC adapters. Slip the adapters over the filter cap inlet and outlet, then connect the appropriate pipes to
the adapters.
3. Push the 100 mesh filter screen (C) into the bottom of the filter cap (A).
4. Place the filter cap O-ring (D) on top of the filter bowl (E). It will fit around the raised lip.
5. Thread the filter bowl (E) into the filter cap (A). Ensure the O-ring (D) stays in place.
v
Item
Quantity
Description
Model Number
A
1
Filter Cap (1 in. slip or 1-1/4 in. spigot)
WSSFFH
B
1
Filter Screen O-ring (pre-attached)
WSSFOR1
C
1
100 Mesh Filter Screen
SFS-100
D
1
Filter Cap O-ring
WSSFOR2
E
1
Filter Bowl
WSSFSB
F
1
Flush Valve
WSSFD
C
E
A
Model #EBSPF-100
SKU #1001-480-246
Installation Guide
Sediment Filter
TM
NOTE: It is recommended that the filter bowl be removed from the PVC body prior to the gluing process, as any excess glue that
comes in contact with the filter bowl will cause damage and void the warranty.
NOTE: The filter should be installed in a location that protects it from damage. Potential filter damage considerations should include
impact, freeze, excessive heat, sunlight, chemical contact and water-hammer.
A
B
D
E
C
NOTE: Use approved PVC primer and solvent cement for gluing PVC
connections. Follow gluing instructions outlined on solvent container.
IMPORTANT: Be sure the arrow on the top cap follows the flow of water.
IMPORTANT: HAND TIGHTEN ONLY. Do not use thread tape or pipe dope on this connection! The O-ring creates the seal.
F