Item # Model #HDS30 HDS50 USE AND CARE GUIDE SUMP PUMP Questions, problems, missing parts? Before returning to the store, call Everbilt Customer Service 8 a.m. - 6 p.m., EST, Monday-Friday 1-800-305-1726 HOMEDEPOT.COM THANK YOU We appreciate the trust and confidence you have placed in Everbilt through the purchase of this sump pump. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Table of Contents Performance Chart ...................................................................5 Materials Required (Not Included) ...........................................5 Installation ..................................................................... 6 Operation ....................................................................... 7 Care and Cleaning ........................................................ 8 Additional Maintenance Guidelines..........................................
Safety Information (continued) WARNING: Support the pump and piping when assembling and when installed. Failure to do so may cause the piping to break, pump to fail, motor bearing failures, etc. WARNING: Check local electrical and building codes before installation. The installation must be in accordance with their regulations as well as the most recent National Electrical Code (NEC).
Warranty (continued) The manufacturer at its discretion may replace or repair any product that fails under this warranty after inspection by an authorized company representative or after the manufacturer has received the product at our factory. Replacement or repair cannot be made until after the product is inspected. All charges or expenses for freight to and from the factory, removal and reinstallation of the product, or installation of a replacement product are the responsibility of the purchaser.
Pre-Installation (continued) PERFORMANCE CHART SKU HDS30 HDS50 HP Volt 3/10 1/2 115V 115V Amps 6.5A 10.0A GPH of Water @ Total Feet of Lift 0 ft. 5 ft. 10 ft. 3160 2850 2150 5100 4460 3450 15 ft. 1500 2840 20 ft. 100 1860 25 ft. 0 550 Max. Lift 21 ft. 26 ft. MATERIALS REQUIRED (NOT INCLUDED) Before using this pump, ensure you have the following items: 1-1/2 in. Discharge pipe 1-1/2 in. Union Thread sealant tape 1-1/2 in. Check valve 1-1/2 in. Nipple pipe 1-1/2 in. Gate valve 5 1-1/2 in.
Ins stallatiion 1 Ƒ Ƒ Conneccting a diischarge pipe to thhe pump 2 Placing tthe pumpp in a bassin Ƒ Wrap the thhreads of the 1--1/2 in. dischargge pipe (1) withh thread sealant tape. Attach the discharge d pipe (1) to the dischharge of the pum mp (2). Place the pum mp on a hard surrface inside a ssump basin. 1 2 3 Conneccting the check vaalve Ƒ 4 2 Connect thee discharge pippe (1) to the elboow (2), union (33), check valvee (4), and gate valve v (5).
Op peratio on 1 Conneccting pow wer and teesting pump operation o n 2 Operatinng the pummp Ƒ NOTE: When W these pumpss are installed in a basin with a sealed covver, switch operattion cannot be obbserved. The sum mp cover usuaally will have a sppare that is pluggged with a rubberr plug. This plug can be remooved and switch operation can bee observed. Ƒ Ƒ Ƒ When the floatt switch (1) movves up over thee top of the pump, the pum mp begins to opperate.
Care and Cleaning WARNING: Ensure the pump is disconnected from the power source before attempting to service or remove any component. WARNING: Do not remove the impeller. Removal of the impeller requires special tools and can only be performed by an authorized service center. To clear a pump that is clogged with debris: Ƒ Ƒ Ƒ Ƒ Ƒ Unplug the pump to disconnect the electrical power. Unscrew the six screws (1) on the pump body and take the rubber belt (4) down from the volute (2). Remove the volute (2).
Troubleshooting WARNING: Before servicing a pump, always shut off the main power breaker and then unplug the pump. Under flooded conditions, make sure you are not standing in water and that you are wearing insulated protective sole shoes. Contact your local electric company or a qualified licensed electrician for disconnecting electrical service prior to pump removal. Problem The pump does not turn on. Probable Cause The pump is not plugged in. The circuit breaker is off or a fuse is missing.
Questions, problems, missing parts? Before returning to the store, call Everbilt Customer Service 8 a.m. - 6 p.m., EST, Monday-Friday 1-800-305-1726 HOMEDEPOT.COM Retain this manual for future use.
