SKU# 784935, 784909 Model# SP03302EP SP05002VD USE AND CARE GUIDE SUBMERSIBLE SUMP PUMP SP03302EP SP05002VD Questions, problems, missing parts? Before returning to the store call Everbilt Customer Service 8 a.m. - 5 p.m., EST, Monday-Friday 1-877-527-0313 HOMEDEPOT.COM THANK YOU We appreciate the trust and confidence you have placed in Everbilt through the purchase of this submersible sump pump. We strive to continually create quality products designed to enhance your home.
Table of Contents Table of Contents .......................................................... 2 Performance .................................................................. 2 Safety Information......................................................... 2 Safety Information (continued) .................................... 3 Warranty ......................................................................... 3 Pre-assembly ................................................................. 4 APPLICATION ........
Safety Information (continued) CAUTION: Know the pump and its applications, limitations, and potential hazards. IMPORTANT: Ensure the electrical power source is adequate for the requirements of the pump. CAUTION: Secure the pump to a solid base. This will aid in keeping the pump in a vertical orientation. This is critical in keeping the pump operating at maximum efficiency. It will also help prevent the pump from clogging resulting in premature failure.
Pre-assembly APPLICATION The submersible pump is designed for water removal applications. Use this pump only for pumping water. It can drain or remove water from the following: pits, sinks, window wells, basements, swimming pool covers, boats, low spots in yards, or other flooded areas. This pump has not been tested or approved for use in swimming pools or in salt-water marine areas. This pump is not designed to function as a permanently installed sump pump.
Pre-assembly (continued) PACKAGE CONTENTS NOTE: The adapter is not shown to scale. B A Part Description A Pump B 1-1/4 in. adapter SPECIFICATIONS Power supply 115V, 60 HZ., 15 Amp Circuit Liquid temp. range 35°F to 77°F(1°- 25°C) Individual branch circuit required 15A Discharge size 1-1/2" FNPT or 1-1/4” FNPT (with adaptor) Sump basin 10 in. (254mm) diameter, 15 in. (381mm) depth 5 HOMEDEPOT.COM Please contact 1-877-527-0313 for further assistance.
Assembly CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug the pump and allow time for it to cool after periods of extended use. 1 3 For 1-1/2” pipe installation, wrap the threads of the 1-1/2 in. with thread tape. Screw the adapter on the pump discharge. Install a 1-1/2 in. or 1-1/4 in. check valve in the vertical discharge pipe. Be sure the flow is away from the pump. Slid down the sump lid.
Operation Plug the pump power cord plug into the piggyback switch plug outlet. Then plug the switch plug into 115V GFCI power outlet, Check the pump by filling the sump pit with water and observe the pump’s operation through one complete cycle. Make sure the pump cannot move in the sump pit and float switch moves freely up and down. When the float switch moves up over the top of the pump, the pump will start operating. When the water lowers to a certain level, the float switch will turn off the pump. .
Care and Cleaning CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug the pump and allow time for it to cool after periods of extended use. Do Do Not Periodically unplug the pump, making certain your hands are dry, and you are not standing in water. When the power is disconnected, inspect the pump inlets and remove all debris, then plug pump back into the grounded (GFCI) outlet. Disassemble the motor housing.
Troubleshooting Problem Pump does not start or run Possible Cause 1. 2. 3. 4. 5. 6. 7. Corrective Action 1. 2. 3. 4. 5. Replace fuse Reset breaker Secure plug Clean plug prongs Unplug for 30 minutes, then plug in 6. Directly plug the power cord into the power source outlet. If the pump works, the switch must be faulty. Replace switch. Blown fuse Tripped breaker Plug disconnected Corroded plug Thermal overload Float switch failed Motor failed 7.
Questions, problems, missing parts? Before returning to the store call Everbilt Customer Service 8 a.m. - 5 p.m., EST, Monday-Friday 1-877-527-0313 HOMEDEPOT.
