Installation Guide

2 For Professional Technical Support call 1-844-241-5521
Table of Contents
Table of Contents .......................................................... 2
Performance .................................................................. 2
Safety Information ......................................................... 2
Warranty ......................................................................... 3
Pre-Installation .............................................................. 3
Installation ..................................................................... 5
Troubleshooting .......................................................... 10
Performance
SKU HP
GPH of Water @ Total Feet Of Lift
Max. Lift
0 ft. 5 ft. 10 ft. 15 ft.
1001194470 1/2 8700 7500 6000 3900 20 ft.
Safety Information
DANGER: Do not install pump in any location classified
as hazardous by National Electrical Code, ANSI/NFPA 70.
Do not smoke or use electrical devices which could
generate sparks or flame in an atmosphere which could
contain septic(methane) gas.
WARNING: Read this manual carefully. Failure to follow
these instructions could cause serious bodily injury and/or
property damage.
WARNING: Check your local codes before installing. You
must comply with their rules.
WARNING: Hazardous voltage. Can shock, burn or
cause death. During operation, the pump is in water.
To avoid fatal shocks, proceed as follows if the pump
needs servicing:
Disconnect power to the outlet box before unplugging the
pump.
Take extreme care when changing fuses. Do not stand in
water or put your finger in a fuse socket.
Do not modify the cord and plug. Plug into a grounded
outlet only. If the system is not properly grounded or you
are not sure, call a licensed electrician for assistance.
Installation and checking of all electrical circuits and
hardware should be performed only by a qualified licensed
electrician.
Make certain that the pump’s power cord will reach the
ground fault interrupter protected receptacle or control
box. Do not use an extension cord with this system.
Connect this pump to a 15 amp circuit breaker on a
dedicated circuit.
CAUTION: Vent sewage or septic tank according to local
codes.
CAUTION: Do not run the pump dry. Dry running can
overheat the pump, (causing burns to anyone handling it)
and will void warranty.
CAUTION: The pump normally runs hot. To avoid burns
when servicing the pump, allow it to cool for 20 minutes
after shut-down before handling it.
NOTE: In normal service, the motor should not need
oiling. The motor has been filled at the factory with a
special oil.