Installation Guide

6 For Professional Technical Support call 1-844-241-5521
Installation (continued)
F. Insert the cords into the split cord grommet (see Repair Parts, Key No. 3), making sure that the cord grommet is right side up (see
Figure 3) and outside the pump chamber. Leave yourself some slack in the cord.
G. Push the lid down into position on the pump chamber. Start bolts in the four corners of the lid to keep it in position on the pump
chamber.
H. Tighten the discharge pipe into the pump discharge with a strap wrench. Do not press the cord grommet into the lid yet.
I. Install and tighten all lid bolts with a 7/16 in. wrench (see Repair Parts, Key Nos. 6, 7).
J. Press the cord grommet into the lid.
9. Glue one half of the 2 in. slip union to the discharge pipe.
WARNING: Fire and explosion hazard. PVC glue is highly flammable. Do not use near fire or flame, and follow glue manufacturer’s
instructions carefully.
10. Glue the other half of the union to one of the close nipples.
11. Glue both nipples into the 90°elbow.
12. Attach the check valve (Repair Parts, Key No.1)to the close nipple that does not have the union attached. Make sure the flange on the
check valve body is toward the pump (see Figure 4).
Figure 4: Check Valve Installation
Figure 3: Cross-section of pump chamber
lid and seals showing correct orientation
of seals.