SKU # 1001627571 Model # UT08804 USE AND CARE GUIDE AUTOMATIC POOL COVER PUMP Questions, problems, missing parts? Before returning to the store call Everbilt Customer Service 8 a.m. - 6 p.m., EST, Monday-Friday 1-844-241-5521 HOMEDEPOT.COM Rev. 05/20/17 THANK YOU We appreciate the trust and confidence you have placed in Everbilt through the purchase of this automatic pool cover pump. We strive to continually create quality products designed to enhance your home.
Table of Contents Table of Contents .......................................................... 2 Performance .................................................................. 2 Safety Information ......................................................... 2 Warranty ......................................................................... 3 Pre-Installation .............................................................. 4 Installation .....................................................................
Safety Information (continued) CAUTION: Know the pump and its applications, limitations, and potential hazards. IMPORTANT: Ensure the electrical power source is adequate for the requirements of the pump. CAUTION: Secure the pump to a solid base. This will aid in keeping the pump in a vertical orientation. This is critical in keeping the pump operating at maximum efficiency. It will also help prevent the pump from clogging resulting in premature failure.
Pre-Installation APPLICATION This automatic submersible utility pump is designed for water removal applications. Pump water only with this pump. It can automatically drain or remove water from the following: swimming pool covers, sinks, window wells, boats, low spot in yards, or other flooded areas. This pump has not been tested or approved for use in swimming pools or in salt-water marine areas. This pump is not designed to function as a permanently installed sump pump.
Pre-Installation (continued) PACKAGE CONTENTS NOTE: The adapter is not shown to scale. Part Description A Pump B 3/4 in. garden hose adapter C Base D GFCI with 25 ft. cord SPECIFICATIONS Power supply 115V, 60 HZ., 10 Amp Circuit Liquid Temp. Range 32°F to 95°F(0°-35°C) Discharge 1 in. Male NPT or 3/4 in.
Installation CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug the pump and allow time for it to cool after periods of extended use. 1 2 Connecting a adapter NOTE: Minimize pressure loss ( or maximize flow rate) by using a larger inner diameter hose or by shortening the hose. Attach the adapter (B) to the pump outlet. Install the pump to the base (C). Connecting a 3/4 in. garden hose or 1-1/4 in.
Operation NOTE: Make certain you unwind the garden hose completely. Kinks in the hose will restrict the pump, preventing it from priming, which is the first step to pumping water. This pump has water detector sensors. As long as the water level is over 2 in., the pump will automatically start operating. Place the pump on the pool cover or solid base that you would like to remove water. And plug the pump power plug into a 115V outlet, protected with a 10 AMP fuse or circuit breaker.
Care and Cleaning (continued) TO CLEAN THE WATER SENSOR HOUSING NOTE: Unplug the power cord. Simple clean the pump 1 Put the pump upside down and flush the bottom of the filter base with clean water. Deep clean the water sensors and impeller 1 2 Pull the snap fittings on the pump housing and remove the pump filter base. 8 Pull the cap up along the pump housing.
Care and Cleaning (continued) 3 4 Clean the debris and contamination around the sensor probes. To clean the pump clogged with debris. Remove the screws (4) and take out the volute (3) from the pump and clean the debris on the impeller (1). Reassemble the volute (3), water sensor housing and sensor protection cap (6), pump base (5). Troubleshooting Problem Possible Cause Corrective Action The pump does not start. 1. If the house fuse is blown. 2.The water level is too low. 3.
Questions, problems, missing parts? Before returning to the store call Everbilt Customer Service 8 a.m. – 6 p.m., EST, Monday-Friday 1-844-241-5521 HOMEDEPOT.
