A' EVERDURE FINELINE FLUELESS RADIANT CONVECTION GAS SPACE REA TER MODELS BRIGADIER - 3725, COMMANDER - 3621, CRUSADER - 3518, LANCER - 2415 Operating and Maintenance Instructions Australian Made By SHRIRO AUSTRALIA PTY. LIMITED EVERDURE DIVISION.
The Everdure Fineline gas space heaters are described as manually operated, portable, flueless radiant convection heaters for use with Natural gas or Liquid Petroleum gas. The heater is supplied with an approved flexible hose. A label is attached to the rear of the heater stating the type of gas for which it has been manufactured and adjusted.
, ~ . . .c' .,' . -" MODEL BRIGADIER 3725 A IJ IT ro
The Data Label, as shown below, is located on the inside of the appliance and can be accessed by opening the lower louvre panel. (Fig. 2, Page 7). (Brigadier model shown). Everdure Model 3725 Gas Type Nom Gas Consumption Test Point Pressure Main Burner Injector Pilot Injector Serial Number A.G.A. Certification No. 4918 Mj/Hr KPa mm mm N.G. 25 0.95 0.86 0.5 LP.G. 25 2.75 0.51 0.
. ~ :-r. -+ MANUAL IGNITION The heater may be manually lit by opening the dress guard (see Cleaning) and while holding down the ignition button, apply a lighted longreach match or taper to the pilot. The ignition button needs to be held down for 20 seconds to allow the valve to lock in. Close up the dress guard as described in the cleaning section. ABNORMAL OPERATION As the heater heats up or cools down, expansion or contraction takes place and the occasional 'click' may be heard.
~ I I ,- IGNITION SWITCH OFF Hold down 'ON' button ~ Dep~ntarilY LOW SETTING BRJGADIER 3 TILES ON COMMANDER 2 TILES ON CRUSADER 1 TILE ON LANCER 2 TILES ON BRIGADIER 5 TILES ON COMMANDER 4 TILES ON LANCER: N/A CRUSADER 3 TILES ON MEDIUM SETTING BRIGADIER 7 TILES ON HIGH SETTING CRUSADER 5 TILES ON COMMANDER 6 TILES ON LANCER 4 TILES ON Low, medium and high settings can be obtained by setting the buttons set as shown in the diagrams above.
. ~ . -c. - , '. " - .,. ..- , .~ DO NOT place articles on or against this appliance. DO NOT use or store inflammable materials near this appliance. DO NOT spray aerosols in the vicinity of this appliance while it is in operation. DO NOT use this appliance in a marine environment.
IMPORTANT: DISCONNECT GAS AND ELECTRICAL SUPPLIES BEFORE CLEANING ANY INTERNAL SURFACES. MALFUNCTIONS CAUSED BY EXCESSIVE LINTING, WILL NOT BE COVERED UNDER WARRANTY. The outer surfaces of the heater should only be cleaned or dusted with a damp cloth. Access to the area in front of the tiles is achieved by opening the dress guard as follows.
- .-- - -.- ._. .' -.' <. - . ," SYMPTOM POSSIBLE CA USE REMEDY Spark failure (1) Faulty igniter (2) Incorrect spark gap (3) Loose or faulty connections Replace Reset to 4.
rI ! 1. Warranty on Everdure Gas Room Heaters covers constructional defects, faulty materials and/or faulty workmanship for a period of36 months from the date of purchase. Replacement or repairs made under warranty are made free of charge provided, if necessary, the heater is delivered to our service department or authorised service agent and freight both ways are paid by the owner. No liability will be accepted for loss or damage in transit. 2.
FOR FUTURE REFERENCE PLEASE DOCUMENT THE FOLLOWING DETAILS AS SOON AS POSSIBLE AFTER PURCHASE PURCHASED FROM:..................................................................................................... NAME: ............................................................................................................................. ADDRESS: .........................................................................................................................
r \ \ \ \ -:;,. .