0 ASSEMBLY, OPERATION & MAINTENANCE INSTRUCTIONS FOR EVERDURE E2GO PORTABLE GAS BARBECUES Models Included: E2GLPC-09B E2GLPC-09G THE EVOLUTION OF PORTABLE OUTDOOR COOKING
1 THE EVOLUTION OF PORTABLE OUTDOOR COOKING
2 OPERATION AND MAINTENANCE INSTRUCTIONS FOR EVERDURE E2GO GAS BARBECUE RANGE E2GLPC-09B & E2GLPC-09G OUTDOOR PORTABLE BARBECUES CONTENTS SECTION PAGE NO.
3 IMPORTANT SAFETY INSTRUCTIONS IMPORTANT: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. Read the safety precautions of this booklet carefully before removing the barbecue from its carton or connecting the barbecue to its gas supply. If you are unsure about anything regarding your barbecue, please contact Everdure on 1300 766 066 before operating your appliance. This Portable barbecue is intended for OUTDOOR USE ONLY. This appliance must NOT be used indoors.
4 3 APPLIANCE DETAILS Gas Type: Burner Pressure: Injector Diameter: Heat Input: Note: ULPG 2.75 kPa Ø1.00 mm 12 MJ/ hr N.G 1.0 kPa Ø1.60 mm 12 MJ/ hr The size of the injector diameter is stamped on one of the hexagon faces (e.g. ‘165’ for Ø1.65mm injector). LENGTH (mm) 870* 888** Barbecue only Barbecue and Trolley WIDTH (mm) 502 502 HEIGHT (mm) 388 983 *NOTE: the length increases by 147mm per servery when the serverys are folded out fully.
5 OUTDOOR INSTALLATION GUIDE This Appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. This appliance must not be used indoors. Do not use your barbecue in garages, porches, sheds or other enclosed areas. The barbecue is not intended to be installed in or used on recreational vehicles (e.g.
6 OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS A fairly protected location is desirable for pleasant and efficient cooking. Try to keep the barbecue sheltered from strong winds as this will drastically reduce cooking efficiency. If this is unavoidable, position the length of the barbecue to be parallel in the direction of the wind. Keep the barbecue level. Check frequently that the burner remains alight when used in conditions of strong wind (through the viewing hole on the left hand side of the chassis).
7 LIGHTING PROCEDURE Read all operating instructions before lighting the appliance. Open the hood before lighting. Make sure the gas control knob is in the ‘Off’ position and open cylinder valve or connect the natural gas supply (after NG conversion only). Make sure the hot plate is in its correct position for cooking with a gap at the front.
8 TROUBLESHOOTING Burner will not ignite when using the igniter: Cylinder valve is not on Turn cylinder valve on Cylinder is empty Replace with a full cylinder Igniter is not sparking Remove plate and visually check ignition box for a spark. Check that the cables to ignition point, or from the valve to the chassis have not broken or disconnected. Also check the alignment of the sparker. If there is no spark, contact Everdure Service. Clean injector with a toothbrush. Do not drill out or use wire.
9 BARBECUE ASSEMBLY The barbecue and hood comes pre-assembled in a single package, but a number of components need fitting to their correct position. Only a medium size Philips screwdriver is needed. For pictures of parts see the parts lists near the end of this booklet. UNPACKING THE UNIT Take the foam covered unit out of the carton, and place on a clean, flat surface. Carefully remove the foam from each end and take off the protective plastic bag (take care not to kink or damage the hose).
10 MAINTENANCE It is recommended that, at the commencement of each barbecue season, the following maintenance be conducted. BURNER 1. Brush the outside of the burners with a stiff brush to remove rust and dirt. GAS SUPPLY 1. Inspect the gas supply hose for any deterioration and replace it if necessary. 2. Test the gas circuit for leaks and remedy any found. OPTIONAL E2GO TROLLEY STAND (IF SUPPLIED) 1. Check all fasteners for tightness and re tighten where necessary to ensure rigidity of the structure. 2.
11 PARTS LIST: E2GO BARBECUE ASSEMBLY NOTE: The e2go trolley is an optional extra.
12 OPTIONAL ACCESSORY: E2GO TROLLEY STAND The e2go trolley stand is a must have accessory to complete the full portability experience. The stand is an optional extra that functions as both a static stand and a mobile trolley for when you are on the go. Plus, it folds in 5 quick steps so it’s truly hassle free.
13 13 THE EVOLUTION OF PORTABLE OUTDOOR COOKING 13
14 NOTES _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ _________________________________________________________________ ________________________________________
15 THE EVOLUTION OF HEALTHY OUTDOOR COOKING A division of Shriro Australia Pty Ltd 23-27 Chaplin Drive Lane Cove NSW 2066 1300 766 066 www.everdure.