Owners Manual

Assembly, Operation & Maintenance Instructions

LIGHTING THE BARBEQUE USING THE BUILT IN

IGNITION ON THE CONTROL KNOBS

1. Read all instructions before lighting.

2. open lid during lighting

3. make sure the gas control knob is in “OFF” position.

4. Push the gas control knob and turn anticlockwise to”HIGH”Position. The ignitor will click

and light the burner

5. If ignition does not occur in 5 seconds, turn the gas control knob o, wait 5 minutes, and

repeat steps 2-5.

WARNING: If any burner extinguishes during use turn the control knobs to the OFF

position and wait 5 minutes to enable any unburnt gas to clear before reigniting your gas

grill.

There are 2 control knobs on the FORCE

barbeques and 3 control knobs on the

FURNACE

barbeques (one for each burner under a plate or grill). The control knob

closest to the rear controls the burner to the right. The control knob closest to the front

controls the burner to the left. The central control knob (FURNACE

barbeque only)

controls the centre burner.

CLEANING & STORAGE

EXTERNAL CLEANING

Before cleaning the barbeque exterior and stand, ensure the appliance has cooled and

is safe to touch. Painted and plastic surfaces can be cleaned using a mild household

detergent or cleaner and a clean cloth (do not use scourers or harsh detergents). It is

advisable to test cleaners on a small section of the appliance rst. NEVER use

paint thinners or similar solvents for cleaning and NEVER pour cold water over hot

surfaces. Dry the surface afterwards.

INTERNAL CLEANING

Before cleaning the internal parts of your barbeque, ensure the appliance has cooled and is

safe to touch. The inside of the hood can be cleaned by using some water, mild detergent

and a sponge or mild scouring pad. The non-stick coated surface of the hot plate should

be cleaned carefully so as not to scratch the surface as above, preferably when the surface

is still warm. For hard to clean areas, use a little baking soda on a wet sponge. Do not use

abrasive cleaners.

WARNING! The surfaces of the plates may be hot. Please ensure protective gloves are worn.

LIGHTING PROCEDURE

READ ALL OPERATING INSTRUCTIONS BEFORE LIGHTING THE APPLIANCE

OPEN THE HOOD BEFORE LIGHTING

MAKE SURE THE GAS CONTROL KNOB IS IN THE ‘OFF’ POSITION AND OPEN CYLINDER/BOTTLE VALVE

MAKE SURE THE GRILL AND PLATE ARE IN THE CORRECT POSITIONS FOR COOKING