User Manual

Troubleshooting
20
‘cht’ or ‘CHt’ appears on the LED alternating
with the current temperature and accompanied
by an audible alarm.
The condenser coil may be clogged with dust, grime
or debris. Clean it following the instructions on page
(15,16)
The room’s ambient temperature may be higher than
86°F (30°C). Provide ample ventilation or additional
cooling to the room. Relocate the unit from extremely
small spaces without ventilation.
The unit may be installed in close proximity to heat
sources such as ovens, stoves, heaters or direct
sunlight. Relocate the unit away from these sources.
The unit may be installed without clearance or proper
ventilation. Provide additional exhaust vents and
observe the clearance allowance specified on page
(3).
The compressor, fan motors or entire system
fails to start
The ON/OFF switch may be set to OFF. Turn to the
ON position and wait for the LED and motors to show
signs of operation.
The power cord may not be connected. Ensure the
connection. In cases of damage to the power cord or
plug, immediately mark the unit as out of order until
the damaged part is replaced.
The outlet may not be sending power or the power
supply breaker may be switched off. Unplug the unit
and contact a licensed electrician for inspection and/
or repairs.
8. Troubleshooting Guide
In most cases, your Everest product may be exhibiting behavior that is typical of standard operation.
Observe the following when troubleshooting symptoms.
The compressor operates continuously or for
prolonged periods.
The condenser coil may be clogged with dust, grime
or debris. Clean it following the instructions on page
(15,16) The door or door gaskets may not be sealing
properly. Check product placement in the cabinet as it
may preven t the door from fully closing. If the gasket
is loose, reattach.
The evaporator coil may be blocked with ice. Defrost it
following the instructions on page Chapter 5. Normally,
evaporator coils will self-maintain with automated
defrost cycles. If the evaporator coil ices up frequently,
re-assess placement of food items in the cabinet as it
could obstruct cold air circulation.
The room’s ambient temperature may be higher than
86°F (30°C). Provide ample ventilation or additional
cooling to the room. Relocate the unit from extremely
small spaces without ventilation.
The unit may be installed in close proximity to heat
sources such as ovens, stoves, heaters or direct
sunlight. Relocate the unit away from these sources.
The unit may be installed without clearance or proper
ventilation. This forces the compressor to operate
constantly in order to maintain cabinet temperature.
Provide additional exhaust vents and observe the
clearance allowance specified on page (15,16).
The cabinet temperature is too warm.
The condenser coil may be clogged with dust, grime
or debris. Clean it following the instructions on page
(15).