User manual

NAV Series TCP/IP Standalone Network Access Controller
30
4.6 Door Setting
EFC301 controls a single door. The user can set the door open time, Door Over Time and
dooropenmode.
Inthe“SystemSetting”mainmenu,scrolltothe“DoorSetting”menuitemandpress“#”to
enterthe“DoorSetting”submenu.Scrolltoselectdifferentmenuitems.



4.6.1 Set Open Time
Thedoor open time isthedoor opentimeafterthevalidcardisswiped orthedoor open
button is pressed and the default value is 3 seconds. The maximum time set on the
controlleris999min
59s.ifthe dooropenbuttonispressed,thedoor willopen.Thedoor open time isstarted
afterthedooropenbuttonisreleased.Scrolltothe“SetOpenTime”menuitemandpress
“#”toenteritsinterface.



For setting the minutes, input three digits in the range of 0‐999, and for setting seconds,
input two digits
 in the range of 0‐59. Press “#”to confirm andthe settingwilltak eeffect.
Press“*”toexitandthesettingwillnottak eeff ect.

4.6.2 Set Over Time
Thedoorstatusswitchisusedtodetecttheopen/closedstatusofthedoor.Ingeneralcases,
thedoorisclosed.In case of dooropening,the doorshouldbeclosedafterbeingopened
for a periodoftime,duringwhich thecontrollermaynotreceivethe signal from the door

status switch. At the end of the door open time, if a door which should be closed is not
closed, timing will start andthe recorded timeis the Door Over Time.When thetime has
exceeded, the controller will generate an alarm. The default Door Over Time is 10s.The
maximumDoorOverTimesetonthecontrolleris999min59s.
Scrollto“SetOverTime”menuitemandpress“#”toenteritsinterface.


Door Over Time
000 Min 10 Sec
Cancel OK
Door Open Time
000 Min 03 Sec
Cancel OK
Set Open Time
Set Over Time
Door Access Mode