User manual

NAV Series TCP/IP Standalone Network Access Controller
75
11 Controller Management
Thischapterwillintroducehowtosetthecontroller.Throughthischapter,youcanlearn:
Howtoadd,deleteandconfigurethecontrollerinthesystemsoftware.
Howtodownloaddataintothecontroller.
11.1 Controller Setting
Clickthe“AccessControl”“Controller,”select“ControllerSetting”toenterthecontroller
settingpage;seethefigurebelow:

Figure 11-1 Controller setting
11.1.1 Change Controller Information
The related configurations of one controller are provided in this operation page of the
controller (see Figure 12‐1), card reader, alarm, alarm time or other settings. Next, the
operationswillbeintroducedindetail.

11.1.1.1 Door Region Setting
In the door region setting page, the user can conduct door region setting of the

corresponding controller, including: Door region position, door open time and door open
timeout.
Door Open Time: The length of time a may remain open after a door open request is
permitted.
Door Over Time: The delay time (unit: S) for triggering a door open timeout alarm event
whentheactualdooropentimeexceedsthesettime.
Input door open time  and door status switch time in the  door region information textbox
andclickthe“Save”buttontofinishtheoperation.

Chapter
11