User`s manual

EQ610s
15
• D/N IN mode must be selected if the camera receives its Day/Night
mode-change signal from an external device that is attached to the
camera via the terminal block. In this submenu you can configure the
Night Input value (High or Low – referring to whether a higher-voltage
signal or lower-voltage signal will trigger Night Mode, depending on the
signal-sending device’s setup) and the Burst value (On or Off).
AUTO and EXTERNAL mode settings
The camera will switch to DAY (Color) mode or NIGHT (B&W) mode
according to the selected values.
• LIVE LEVEL: This indicates the current light level.
• DAYNIGHT: When the camera detects the current light level is lower than
this value, it’ll switch from DAY mode to NIGHT mode. Selectable values are
0~63.
• NIGHTDAY: When the camera detects the current light level is higher than
this value, it’ll switch from NIGHT mode to DAY mode. Selectable values are
0~63.
Note:
1. The difference in the selected values of DAY NIGHT and NIGHTDAY
should be more than 5, or else the camera might keep switching from
DAY NIGHT and NIGHTDAY constantly.
2. It is not recommended to use an infrared illuminator when the camera is
in DAY/NIGHT > AUTO mode.
• DELAY TIME: The Delay Time will keep the camera from unnecessarily
switching between Day and Night modes when there is a sudden and short
change in the light levels. The camera will switch from one mode to the
other only if a switch-inducing change in light levels stays the same for the
selected number of seconds. The selectable values are 0 to 255 seconds.
Submenu of the DAY / NIGHT > AUTO and EXTERNAL modes
** DAY/NIGHT AUTO **
LIVE LEVEL
||||||||||||||||||||| 063
DAY->NIGHT
||||||||||||||||||||| 003
NIGHT->DAY
||||||||||||||||||||| 025
DELAY TIME
||||||||||||||||||||| 005
BURST
OFF
RETURN<┘