Product Specs

EVERINT

émetteur.

IMPORTANT NOTE

This device complies with FCC & ISED radiation exposure limits set forth for an uncontrolled

environment. This device should be installed and must not be co-located or operating in

conjunction with any other antenna or transmitter.

This device is intended only for OEM integrators under the following conditions:

1) This module may not be co-located with any other transmitters or antennas.

2) The antenna must be installed such that 20cm is maintained between the antenna and

users.

As long as 2 conditions above are met, further transmitter test will not be required. However,

the OEM integrator is still responsible for testing their end-product for any additional

compliance requirements with this module installed.

In the event that these conditions cannot be met, then the FCC & IC authorizations are no

longer considered valid and the FCC ID cannot be used on the final product. In these

circumstances, the OEM integrator will be responsible for re-evaluating the end product

including this module and obtaining separate FCC & IC authorizations.

- End Product Labeling

To satisfy FCC exterior labeling requirements, the following text must be placed on the

exterior of the end product.

Contains Transmitter module FCC ID: 2AKMF-BT-MSO4

IC: 22266-BTMSO4

- Manual Information to the End User

The OEM integrator is responsible for ensuring the end-user has no manual instruction to

remove or install module.

The end user manual shall include all required regulatory information/warning as show in this

manual.