Product Specs

RSS-102 RF Exposure
L’antenne (ou les antennes) doit être installée de façon à maintenir à tout instant une
distance minimum de au moins 20 cm entre la source de radiation (l’antenne) et toute
personne physique.
Cet appareil ne doit pas être installé ou utilisé en conjonction avec une autre antenne ou
émetteur.
IMPORTANT NOTE
This device complies with FCC & ISED radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions:
1) This module may not be co-located with any other transmitters or antennas.
2) The antenna must be installed such that 20cm is maintained between the antenna and
users.
As long as 2 conditions above are met, further transmitter test will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements with this module installed.
In the event that these conditions cannot be met, then the FCC & IC authorizations are no
longer considered valid and the FCC ID cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
including this module and obtaining separate FCC & IC authorizations.
- End Product Labeling
To satisfy FCC exterior labeling requirements, the following text must be placed on the
exterior of the end product.
Contains Transmitter module FCC ID: 2AKMF-BTTYPEA
IC: 22266-BTTYPEA
- Manual Information to the End User
The OEM integrator is responsible for ensuring the end-user has no manual instruction to
remove or install module.
The end user manual shall include all required regulatory information/warning as show in this
manual.