Product Specs

Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to
Part 2.1091(b).
3. The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to
verify compliance as a composite system. When testing the host device for compliance with Part
15 Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart B
while the transmitter module(s) are installed and operating. The modules should be transmitting
and the evaluation should confirm that the module's intentional emissions are compliant (i.e.
fundamental and out of band emissions). The host manufacturer must verify that there are no
additional unintentional emissions other than what is permitted in Part 15 Subpart B or
emissions are complaint with the transmitter(s) rule(s). The Grantee will provide guidance to the
host manufacturer for Part 15 B requirements if needed.
Important Note
notice that any deviation(s) from the defined parameters of the antenna trace, as described by
the instructions, require that the host product manufacturer must notify to EVERINT Co., Ltd.
that they wish to change the antenna trace design. In this case, a Class II permissive change
application is required to be filed by the EVERINT Co., Ltd., or the host manufacturer can take
responsibility through the change in FCC ID (new application) procedure followed by a Class II
permissive change application.
Antenna Installation
(1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) Only antennas of the same type and with equal or less gains as shown below may be used
with this module. Other types of antennas and/or higher gain antennas may require additional
authorization for operation.