Grow Light USER MANUAL READ AND SAVE THESE INSTRUCTIONS Inspect Unk Before Usa, Contact immediately for any darn aged or defective units.
TABLE OF CONTENTS Ell components maintenance EI chary E separatist EE assembly Fl TROUBLESHOOTING 3 ope Ration 1.
2. SAFETY * PLEASE READ CAREFULLY BEFORE USE & SAVE THESE INSTRUCTIONS | caution] DO NOT STARE INTO THE LIGHTS! IIE ONLY FOR INDOOR LSE. EB use this grow light only as described in this manual, Any other use not recommended by the manufacturer may cause fire, electric shock, or personal Injury, [7 boot allow the Inside of the grow light to corner wet during operation or in storage. Always store in a dry area free from potential moisture. CEE ET 00 NOT Immerse the grow light in water.
WHEN USING AN ELECTRICAL APPLIANCE, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING: Oo poop HEE pops Thoroughly Inspect the unit in its entirety for any cracks, chips, or damage that could cause the unit to malfunction. D0 NOT use if damage is found. Only » professional or authorized repairman should repair this appliance. Keep the grow light and all of t's packaging away from children and infants.
3. ASSEMBLY BI Remove the plastic film tab B1 Unscrew the protective cap from from the battery compartment the center of the tripod of the remote control. assembly. ON Sans 2nd already in the remote. £1 Hold the tripe assembly while £1 Pull the center rod seasoning the retaining screw abase the tripod legs and that secures the center red in re tighten the retaining screw to place {second retaining screws secure the center rod. mm the top).
[i Commectthetripod'scenterrod [Extend the tripod legs by to the base of the grow light seasoning the bottom retaining assembly and fully tighten it. screw and pulling the legs down from the base of the tripod.
6 Adjusting the grow light's {5 Before operating the Grow Light, eights remove any plastic packaging, including each amp eds protective film.
4. OPERATION 1 Adjust each LED lamp head touts § Connect the grow light cord to desired angle and position in the power adapter and plug it proximity to your plants. into a standard wall socket. El Tum on the light via the wired Set all Aughts, or each Individual control module or by using the light, to the desired light mode. remote control.
OPERATIONAL MODES THE EVERLASTING COMPORT GROW LIGHT OFFERS TWO OPERATIONAL MODES; Default Mode: All Lights On Program Mode {Settings Button): Programs each Individual light for straightness, rotor, and time. HH BOTH DEFAULT AND PROGRAM MODE, YOU CAN Control brightness by cycling through Tl dimming functions. Control carol by cycling through 7 different colors.
SING THE WIRELESS REMOTE and WIRED CONTROL MODULE: ON and OFF: Turns the lights on and off RIGHTNESS CONTROL: Changes the brightness of all of the lights in default skate or individualist lights in programming mode. LIGHT COLOR MODE: Changes the color of all the lights in default state or individual lights in programming mode.
5. MAINTENANCE Unplug the unit and use a water dampened cloth to clean the unit. Do not spray the unit with household cleaners. 6. HELPFUL TIPS Determine the best light color, brightness and timing for your Indoor plants. 7. TROUBLESHOOTING he PRIMARY CA isolation Unit doss'tappesr | Unit Ts on bits may net Aka sure unit is plugged In and totem on. seem ike receiving electricity.
c us Intertwine 5003917 5 Fou, sing Lemnfor® | HAVE AN ISSUE BOTH YOUR GROW LIGHT? Enjoy hassle-free replacements: if your raw ght Is defective or damaged, we will ship you 3 new one ABSOLUTELY FREE.