Datasheet

LifecyclePhase:
Revision : 1
Expired Period: Forever
Release Date:2011-09-14 10:22:42.0
Technical Data Sheet
Full Color Top View LEDs
67-03/BHGHR6W-B11/2T
Everlight Electronics Co., Ltd. http://www.everlight.com Rev. 1 Page: 13 of 14
Device No. : DSE-0005689 Prepared date: 06-Sep.-2011 Prepared by: Ryan Chen
Pre-heating
150~200°C
60~120sec.
3°C/sec.Max.
Above 217°C
60~150sec.
260°C Max.
10sec. M ax.
6°C/sec.M ax.
Above255°C
30sec.Max.
Precautions for Use
1. Over-current-proof
Customer must apply resistors for protection; otherwise slight voltage shift will cause big current
change (Burn out will happen).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30 or less and 90%RH or less.℃
2.3 After opening the package: The LED's floor life is 168 hr under 30 or less and 60% RH or℃
less. If unused LEDs remain, it should be stored in moisture proof packages.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
storage time, baking treatment should be performed using the following conditions.
Baking treatment: 60±5 for 24 hours.℃
3. Soldering Condition
3.1 Pb-free solder temperature profile
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.