Datasheet

EVERLIGHT ELECTRONICS CO.,LTD.
11-21SURC/S530-A2/TR8
Everlight Electronics Co., Ltd. http://www.everlight.com Rev.1.0 Page: 9 of 9
Device No. : DSE-111-080 Prepared date: 08-02-04 Prepared by: Kenny Wang
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 280℃ for
3 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and
more intervals, and do soldering of each terminal. Be careful because the damage of the
product is often started at the time of the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is
unavoidable, a double-head soldering iron should be used (as below figure). It should be
confirmed beforehand whether the characteristics of the LEDs will or will not be damaged
by repairing.
E
VERLIGHT ELECTRONICS CO., LTD. Tel: [phone]
Office: No 25, Lane 76, Sec 3, Chung Yang Rd, Fax: [phone]
Tucheng, Taipei 236, Taiwan, R.O.C http://www.everlight.com