Don't fully tighten until assembly is completed. Align support crossbars (#22) to the holes of the bottom crossbar (#21), then secure with bolts (#H). Align support crossbars (#22) to the holes of the top crossbar (#20), then secure with bolts (#G). Align top crossbar (#20) to the top holes of the side frames (#23), then secure with bolts (#I). Align bottom crossbar (#21) to the bottom holes of the side frames (#23), then secure with bolts (#I).
Attach wood dowels (#C) and cam pins (#A) to the respective holes as shown in the picture. OPTIONAL: Use a dab of glue on each wood dowel. Fully extend left slide rails (#17), then align slide rail (#17) to the holes of the middle left panel (#4). Secure with screws (#D). Metal plate that sticks out is the front of the rail. Fully extend right slide rails (#18), then align slide rail (#18) to the holes of the middle right panel (#5). Secure with screws (#D).
1) Align and place left panel (#2), right panel (#3), middle left (#4), middle right (#5), and back panel (#6) to the top panel (#1) as shown in the picture. 2) Insert cam locks (#B) to any holes with a cam pin head (#A) sticking out. Make sure the gap of the cam lock (#B) fits in with the cam pin head (#A). Secure by turning the cam locks (#B).
Align the bottom panel (#8) to the holes of the table top panels. Secure with screws (#E). OPTIONAL: Apply a dab of glue on wood dowel. Attach cam pins (#A) and wood dowels (#C) to the holes of the front drawer (#9).
1) Align left drawer (#10) and right drawer (#11) to the holes of the back drawer (#12) as shown in the picture. Secure with screws (#E). 2) Attach the front drawer (#9) to the rest of the drawer. Secure the cam pin heads (#A) with cam locks (#B). 3) Align the handle (#19) to the holes of the front drawer (#9), then secure with bolts (#F). Flip the drawer to the back. Slide bottom drawer (#13) so it fits and aligns with the cam pins and panel holes. Secure with screws (#E) and cam lock (#B).
Align the frame to the holes of the bottom panel (#8) then secure with bolts (#H). Extend the rails, then rest and align the drawer to the rails.
Attach the small wine holder (#15) and large wine holder (#16) to the holes of the drawer. Carefully place and rest glass (#14) onto the table top.
