Installation Guide

ManualsBrandsEverpure ManualsHome & KitchenEverpure H-1200 Water Filter Replacement Cartridge Set (EV9282-01)

Thank you for purchasing an Everpure commer

cial-grade water

ltration system for your home. With your Everpure system, you

get premium quality water direct from your tap that’s great-tasting,

healthful and convenient for you and your family.

Product Speci

cations:

For Cold Water Use Only

Temperature Range: 35-100°F (2-38°C)

Min.-Max. Working Pressure: 10-125 psi (0.7-8.6 bar)

Service Flow Rate: 0.5 gpm (1.9 Lpm)

•

INSTALLATION INSTRUCTIONS

Product Speci

cations................................. . Page 1

Tools Required ..................................... . Pages 3,5

Basic Installatio

n Instructions . . . . . . . . . . . . . . . . . . . . . . . . Page 3–5

H 1200 Installation Instructions ...................... . Page 5–6

Claims & Notes........................................ . Page 6

Water Filtration System

EV3070-43 Rev W AP07

Summary of content (7 pages)

PAGE 1
Water Filtration System Thank you for purchasing an Everpure commercial-grade water ltration system for your home. With your Everpure system, you get premium quality water direct from your tap that’s great-tasting, healthful and convenient for you and your family. Product Speci cations: • For Cold Water Use Only • Temperature Range: 35-100°F (2-38°C) • Min.-Max. Working Pressure: 10-125 psi (0.7-8.6 bar) • Service Flow Rate: 0.5 gpm (1.9 Lpm) INSTALLATION INSTRUCTIONS Product Speci cations. . . . . . . .
PAGE 2
Notes • Notas • Remarques •2•
PAGE 3
THE OWNER’S GUIDE IS APPLICABLE FOR THE FOLLOWING EVERPURE FILTER MODELS: Model H-104 Rated Capacity: 1,000 G (3780 L)* Model H-300 Rated Capacity: 300 G (1140 L)* Model H-300-HSD Rated Capacity: 300 G (1140 L)* Model H-300+M Rated Capacity: 500 G (1892 L)* Model H-1200 Rated Capacity: 1,000 G (3780 L)* * For optimum performance, cartridge replacement is required once a year, or sooner if flow becomes too slow for convenience, or if the unit’s rated capacity is reached.
PAGE 4
ENGLISH 3. MOUNT FILTER HEAD UNDER SINK A. Identify Filter Head and the two Elbow Fittings, and note that the Outlet Fitting has a black band. This fitting includes a small restrictor insert to insure maximum flow at 1/2 gallon per minute. B. Apply Teflon Tape to the threads of each Elbow Fitting. Wrap tape in direction of the threads to assure a tight fit and avoid small leaks. C. Screw Inlet Elbow Fitting into the left side of the filter head, and hand tighten only. D.
PAGE 5
6 Q S Label R V ENGLISH 6. INSTALL AND FLUSH FILTER CARTRIDGE Q. Lift handle of the build-in shut off (QC Valve) on the Head. R. Hold Head firmly with one hand. S. Align cartridge lug with label on filter Head. T. Insert filter Cartridge – Push upwards. U. Turn it to the right – About 1⁄4 turn – Until rotation stops. V. Open Side Valve of Angle Stop Adaptor and check for leaks up to Inlet Elbow Fitting. W. Open Filtered Water Faucet. X. Lower the QC Valve Handle to flush water to the sink.
PAGE 6
ENGLISH 2. VERIFY UNDER-SINK MOUNTING LOCATION Measure 22” from the base of the cabinet, and mark the mounting location for the top of the filter head. Measure 13” for the width required for the H 1200 System with dual cartridges. Make sure there is adequate space above the head to open and close the shut-off valve and to avoid crimping the water line tubing. Also, make sure your chosen location offers easy access for future cartridge changes.
PAGE 7
Limited Warranty Garantía limitada Garantie limitée You have just purchased one of the finest water treatment units made. As an expression of our confidence in Everpure products, this product is warranted against defects in material and workmanship to the original end-user when installed in accordance with Everpure specifications.