User's Manual

2
The Transmitter is designed to emit the ID code to the ON/OFF Receiver (B410N)
and Dimmer Receiver (B410D). The procedure of learning the ID code by the
Receiver is clearly described on the Receiver’s manual.
4. Operation
By making use of 4 buttons, the Transmitter is able to control the ON/OFF
Receiver (B410N) and Dimmer Receiver (B410D) as follows:
Transmitter ON/OFF Receiver Dimmer Receiver
1-ON ON ON Dimmer ON,
Start/Stop
1-OFF OFF OFF Dimmer OFF
2-ON ON ON Dimmer ON,
Start/Stop
2-OFF OFF OFF Dimmer OFF
5. Troubleshooting
Symptom Recommendation
Press button, LED not illuminating 1. Reverse battery polarity
2. Run out of battery
No response with the Receiver 1. Check if learning the ID code has
been processed
2. Check if the procedure of ID code
learning is correct
6. Specification:
Battery Type CR2032 3V x 1 pc
Transmitting Range 30 meters min. (in an open space)
Frequency Range 314~316 MHz
**Specifications subject to change and improvement without notice. INB410REVSP0E1A
Mobile of end product
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
Important Note:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment.
To maintain compliance with FCC RF exposure compliance requirements,
please avoid direct contact to the transmitting antenna during transmitting.
This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.