User's Manual

Introduction

This package is designed to facilitate the users who intend constant

observation of the particular place where continuous caring or surveillance is

needed. Both Camera and Monitor units are suitable for indoor use only.

Either 4 AA-size batteries or an AC adaptor can be used as their power source.

When the battery level falls below an acceptable level, the “LOW BATTERY”

indicator on the front of the Camera and Monitor will light up. When this occurs

the batteries should be replaced as soon as possible.

Setting Up the Camera

Power Supply

The Camera adopts either 4 AA-size batteries (no supplied) or the AC adaptor.

Loading the Batteries

1. Open the battery compartment cover on the rear of the camera.(Fig. 3)

2. Insert 4 AA-size batteries, ensuring that correct polarity is put. (Fig. 3)

3. Refit the battery compartment cover and make sure it is locked securely.

Note: Never mix old batteries with new ones.

Remove the batteries from the Camera if you do not plan to use it for a

long period of time.

Fig. 3

Using the AC adaptor

Plug one end of the provided power adaptor into a wall outlet and the other end

into the Camera. (Fig. 4)

Fig. 4

Installing the Camera

The Camera is suitable for mounting in dry interior locations only. 3 types of

installation can be made, such as wall mount, table stand or clip-on the crib.

Place the Camera in a convenient location, point the lens towards the

observed area and adjust the angle by adjusting the lens head vertically. (Fig.

Fig. 5

Wall Mounting the Camera

Note: The Monitor reception should be tested before fixing the camera in place.

Ideally you will need someone to hold the Camera against the wall in the

selected mounting area while you check the reception on the Monitor. If

interference or other problems occur, refer to the Troubleshooting. You may

need to select a different location in the room for mounting the Camera.