User's Manual

1. Decide on the appropriate mounting location. Drill two holes 32mm apart in

a line and fit wall plugs. (Fig. 6)

2. Insert fixing screws until almost fully home and hang the Camera over

these screws using the two keyhole slots in the rear of the Camera. (Fig. 6)

Fig. 6

Clipping on the Camera

1. Use the clip as supplied for fixing the Camera on the crib or table edge.

(Fig. 7)

2. Place the clip to the two slots on the top of Camera and lift it up to fit it in

place. (Fig. 7)

Note: For removing the clip, push the clip downward. (Fig. 8)

Fig. 7 Fig. 8

Operating the Camera

1. Set the channel switch (numbered 1~4) that matches to that of the Monitor

you plan to observe. (Fig. 9)

Fig. 9

Note: If more than 2 cameras are in use, do not set the same channel at

the same time.

2. In the daytime, slide the NIGHT/COLOR/OFF switch to the COLOR

position, so that colorful image will be revealed on the Monitor. (Fig. 9)

3. In the nighttime where ambient light level is insufficient, slide the

NIGHT/COLOR/OFF switch to the NIGHT position for monochrome image

display. (Fig. 9)

4. When the low battery LED lights up, replace batteries immediately.

5. Under normal operation, the power LED should be on.

Setting Up the Monitor

Power Supply

The Monitor uses either 4 AA-size batteries (not supplied) or the AC adaptor.

Note: When replacing batteries or connecting to the AC adaptor, turn off the

Monitor.