User's Manual

Fig. 13

Hanging up the Monitor

On the top of the rear of Monitor, penetrate a string through the hole.

Operating the Monitor

1. Upon reception from the Camera, 3 modes can be selected by pressing

the mode selection button on the front of Monitor.

a. Audio/video mode: The Monitor is on continuously, emitting sound

and image. Under this mode, both and LEDs will not illuminate.

(Fig. 14)

b. Audio mode: The Monitor only delivers audio and LED will light up.

(Fig. 14)

c. Audio-activated mode:

This audio-activated mode allows you to set the sensitivity of audio

level that will trigger the Monitor. To use audio-activated function,

follow these steps:

c-1: Set the sensitivity control on the Monitor to the level you prefer.

Note: The sensitivity level can vary between 0 to 9. A value of 0

gives minimum sensitivity, a value of 9 gives maximum sensitivity.

c-2: Press the mode selection button on the front of the Monitor until

the LED lights up.

c-3: When the sound from the Camera reaches the set level, the

Monitor will turn on automatically, accompanying two beeps and

image. It will turn off automatically after 30 seconds.

c-4: Pressing the Brightness/Contrast Ratio control will turn on the

Monitor for impromptu surveillance.

Fig. 14

2. Volume/Power control: It allows you to adjust the audio level received from

the Camera. (Fig. 15)

Note: The audio level can vary between 0 to 9. A value of 0 gives

minimum level, a value of 9 gives maximum level.

3. Channel selection: 4 channels are available by pressing CH selection

button on the front of the Monitor. The channel sequence will be rotated

once by pressing the button each time. (Fig. 14)

Fig. 15