User's Manual

6
4. Brightness/Contrast Ratio Control: The brightness and contrast ratio
control for the Monitor can be adjusted by pressing the below button: (Fig.
14)
: Increase brightness
: Reduce brightness
: Increase contrast ratio
: Reduce contrast ratio
5. When the battery level drops, the LED will be in red. Battery
replacement should be taken as soon as possible. If everything is ok, the
LED will be in green.
Other Applications
Recording on a VCR / Monitoring from a TV
1. The Monitor comes with an A/V output jack for connecting to a TV or VCR
for monitoring/recording. (Fig. 16)
2. Connect the mini plug of the provided A/V cable to the A/V jack on the side
of the Monitor. Connect the other end of the cable to the A/V jacks of the
A/V components labeled LINE IN. (Fig. 16)
3. The Monitor serves as a receiver to receive the RF A/V signal from the
Camera or other A/V device for recording or displaying.
Fig.16
Serving as an A/V Sender
1. The Camera comes with an A/V input jack for connecting to a DVD/video
device for signal transmission. (Fig. 17)
2. Connect the mini plug of the provided A/V cable to the A/V jack on the side
of the Camera. Connect the other end of the cable to the A/V jacks of the
A/V components labeled LINE OUT. (Fig. 17)
3. The Camera serves as an intermedium to emit the image and sound from
a DVD/video device via 2.4GHz RF technology to the Monitor.
Fig. 17
Troubleshooting
Status Possible Cause Remedy
Power indicator
LED does not
light up
a. Reverse polarity
b. Run out of battery
c. Wrong polarity on DC
adaptor plug
a. Follow the polarity
shown inside the battery
compartment for loading
the batteries
b. Replace new 4 AA-size
batteries
c. Change the polarity of
DC plug
Ambiguous
image under
observation
a. Channel has been
interfered
b. Receiving/t
ransmission
distance too far or radio
wave has been blocked
a. Check that the channel
switches on the camera
and monitor are set to
the same number
b. Reposition the Camera
or Monitor
INC420UEVSP0E1A