User's Manual

2
camera and another person to look at your television when
adjusting the position.
You can mount the camera on the wall or ceiling according
to your need.
a. Connect the 9VDC 500mA power adapter with the
PIR camera.
b. Use the fixing template provided to mark the
position of the two fixing holes (on the wall or on the
ceiling.) Drill two 4mm-diameter holes at the
marked locations, fully insert the plastic wall plugs
supplied, then thread a supplied screw into each
plug, letting the heads extend about 5 mm from the
wall.
c. Take off the rubber cover on the right side of the
camera bracket.
d. Adjust the Channel Switch knob on the right side of the
camera bracket to set up a channel (channel 1,2,3,4).
And remember which channel you selected.
e. Put the rubber cover back to the right side of the
camera bracket.
Step 2: Install the Receiver Unit
(Two versions available: European and American)
European Version
To connect Receiver to your TV:
1. Plug the 1M Scart connector cable that package
included into your TV.
2. Plug the other end, yellow (video), white (audio) and
red (trigger) RCA connectors into the corresponding
RCA connectors on the Receiver.
American Version
To connect Receiver to your TV:
1. Plug the yellow (video) and white (audio) RCA
connectors into TV socket.
2. Plug the yellow (video) and white (audio) RCA
connectors into the corresponding RCA connectors on
the Receiver.
Step 3: Install option accessory VCR
Controller
By adding the optional VCR Controller (C755) in AUX outlet
of the Receiver will enable the system to automatically
record the images and voices when Camera detects
movement. The VCR Controller will automatically switch
your VCR on to Record for one minute and stop recording.
If re-triggered, resume the same step accordingly. (Please
refer to C755 manual for installation and operation.)
OPERATING INSTRUCTION
1. Buzzer/Light ON/OFF SW: Select “Buzzer/Light SW” at
“ON”. When the PIR Camera is triggered, the Receiver
sounds “Beep” twice in response and the Trigger LED
will flash for 1 minute, subject to channel not being
switched.
Note: Buzzer can be turned off by setting “Buzzer/Light
Sw” at the middle position. When the PIR Camera is
triggered, the Receiver will be mute and the Trigger
LED will flash for 1 minute, subject to channel not being
switched.
2. Connect the Receiver with DC12V power adapter and
set the Receiver in the same channel as that of PIR
Camera.
Note: When turning on the power on the Receiver, it
will respond with one “Beep” and the Power on/off LED
will illuminate steadily.
3. Connect the PIR Camera with the 9V power adapter
and turn on the TV. The Camera images can be
viewed right from the TV. The PIR Camera requires
about 1 minute as warming up duration after
connecting to the power adapter. During this duration,
the PIR Camera will ignore any trigger that may
happen. After the elapse of 1 minute, the PIR Camera
will start detecting.
4. When the PIR Camera is triggered:
4-1 Not switching the channel:
When triggered, the signal of Camera image will
shut down for a while and the Trigger LED on the
Receiver will flash and beep twice, activating the
VCR Controller for recording for one minute.
After the elapse of one minute, the VCR Controller
will stop recording.